Sealey AP6601.V2 User manual

INSTRUCTIONS FOR:
MID-BOX/TOPCHEST/ROLLCAB -
HEAVY DUTY
MODEL No's: AP6601.V2/6610.V2/6612.V2
Thank you for purchasing a Sealey product. Manufactured to a high standard these products will, if used according to these instructions and
properly maintained, give you years of trouble free performance.
1. SAFETY INSTRUCTIONS
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCTS CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH THEY ARE INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE
AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1.1. GENERAL SAFETY
WARNING! Ensure Health & Safety, local authority, and
general workshop practice regulations are adhered to when
using these units.
Locate the units in a suitable work area.
Keep the work area clean, uncluttered and ensure there is
adequate lighting.
WARNING! Use the Rollcab on level and solid ground,
preferably concrete.
Keep the units clean and tidy in accordance with good
workshop practice.
Keep children and unauthorised persons away from the work
area.
DO NOT use these units for any purpose other than that
for which they are designed.
DO NOT use the units outdoors.
DO NOT place the units in a damp or wet location or an
area where there is condensation.
DO NOT clean the units with any solvents which may
damage the surfaces or the protective coating.
 DO NOT move the units with the drawers out. To avoid
tipping, open one drawer at a time and close and secure all
drawers whilst moving the rollcab.
 DO NOT step on the drawers.
 DO NOToverload the drawers, weight limit per drawer is
36kg.
© Jack Sealey Limited
AP6612.V2
AP6610.V2
AP6601.V2
Original Language Version AP6601.V2, 6610.V2, 6612.V2 Issue: 1- 12/07/16
2. ASSEMBLY AND USE
2.1. These units are heavy, obtain the help of at least one other person before attempting to unpack them.
(AP6612.V2)
2.2. Attach the wheels to the bottom of the rollcab using 4 bolts, washers and spacers (if supplied) per wheel.
The braked swivel wheels should be mounted on the same end as the handle (left hand side), the normal swivel wheels
 inthemiddleandthelockedwheelsatthefarend(g.1).
2.3. Mountthesidemountedhandleontothecabinetandattachwith4boltsandwashers(g.3).
(All units)
2.4. AP6610.V2 or AP6601.V2 can be placed on top of AP6612.V2, alternatively all 3 units can be assembled together as in
the picture below.
2.5. To remove a drawer with roller sliders, pull the drawer completely out, press down the left tab and lift up the right tab, pull
 drawerofftheslides(g.2).Toreinstallthedrawer,realignwiththeinternaldrawerslideandpushuntilitlocksinplace.
IMPORTANT: To avoid tipping, open one drawer at a time and close and secure all drawers whilst moving the rollcab/
units.
2.6. Periodically lubricate wheel axles and tighten all nuts and bolts.

NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
Fig.1 Fig.2 Fig.3
01284 757500
01284 703534
[e-mail]
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
Environmental Protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
© Jack Sealey Limited Original Language Version AP6601.V2, 6610.V2, 6612.V2 Issue: 1- 12/07/16