Sealey AP6310BE User manual

MOBILE TOOL CABINET 1600MM WITH
POWER TOOL CHARGING DRAWER
MODEL NO: AP6310BE
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETYi
1.1. GENERAL SAFETY
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using these units.
WARNING! Use the Rollcab on level and solid ground, preferably concrete.
9Keep the work area clean, uncluttered and ensure there is adequate lighting.
9Keep the units clean and tidy in accordance with good workshop practice.
9Keep children and unauthorised persons away from the work area.
8DO NOT use these units for any purpose other than that for which they are designed.
8DO NOT use the units outdoors.
8DO NOT place the units in a damp or wet location or an area where there is condensation.
8DO NOT clean the units with any solvents which may damage the surfaces or the protective coating.
8DO NOT move the units with the drawers out. To avoid tipping, open one drawer at a time and close and secure all drawers whilst
moving the rollcab.
8DO NOT step on the drawers.
8DO NOT overload the drawers, weight limit per drawer is 36kg.
2. INTRODUCTION
All heavy-duty steel construction and manufactured with steel inner walls for extra strength and durability. Heavy-duty 45mm ball
bearing drawer slides provide superior performance, suitable for heavier loads. Full height rear locking mechanism, locks smooth
 runningsoftclosedrawersinplace.Rustandsolventresistantblackcrinklee󰀨ectnish.FittedwithsixØ125mmPPwheelswith
 blackchromee󰀨ectalloys,twocastorswithquickreleaseanti-rotationtoelocksandtwoxedwheels.Eachdrawerfeaturesstylish
 blackanodizedheavy-dutydrawerpullspluspre-cutnon-slipliners.Powertoolchargingdrawerttedwith2x230Vsockets&2x
 5V2.4AUSBsockets.Mountingpointstotadditional4gangpowerstrip-ModelNo.EL34USBB(notincluded)Stainlesssteel‘ip-
top’ split equally into two sections providing a work surface and additional storage. Two cylinder locks allow drawers and power tool
charging drawer to be locked separately.
3. SPECIFICATION
MODEL NO.: ....................................................... AP6310BE
Dimensions(WxDxH):.......................1600x585x990mm
Net weight:................................................................... 182kg
4Gangpowerrail(optional)................................. EL34USBB
4. CONTENTS
5. ASSEMBLY
5.1. These units are heavy, obtain the help of at least one other
person before attempting to unpack them.
5.2. Mount the side mounted handle onto the left hand end of cabinet
 andattachwith4bolts(item1)(g.1).
5.3.  Mountthestoragehooksusingbolts(item1)ateachendofthe
 cabinet(g.2)oralternativelymountonesetofhooksonreverse
 faceofeitherleftorrighthandendofcabinet(g.2).
AP6310BEIssue129/01/19
Original Language Version
© Jack Sealey Limited
Refer to
instruction
manual
Item Description Quantity
1 BoltM6x16mm 14
2Handleg.1 1
3 Storagehooksg.2 4
4BoltM3x10mm
(notshown)
4
5Bottleopenerg.4 1
fig.1
Unit element WD H
Toplongdrawer(x1) 1036 482 69
Leftsmalldrawer(x3) 641 482 68
Leftlargedrawer(x1) 641 482 204
Rightsmalldrawer(x4) 326 482 47
Rightlargedrawer(x1) 326 482 212

5.4.  Toremoveadrawerwithrollersliders,pullthedrawercompletelyout,pressdowntherighttabandliftupthelefttab,pulldrawero󰀨
 theslidesToreinstallthedrawer,realignwiththeinternaldrawerslideandpushuntilitlocksinplace(g.3).
5.5.  Fitbottleopenertothelefthand(handle)endofthecabinetusingtwoM6x16mmbolts.(g.4).
5.6.  Mountingholesforanadditionalpowerrail(EL34USBB-notincluded)areprovidedatbothendsofthecabinet and mounting bolts
 (item4)areprovidedwiththecabinet.
IMPORTANT:Toavoidtipping,openonedraweratatimeandcloseandsecurealldrawerswhilstmovingtherollcab/units.
6. MAINTENANCE
6.1.  Periodicallylubricatewheelaxlesandtightenallnutsandbolts.
6.2.  Keepallsurfacesclean.Brusho󰀨andwipedownwithdampclothandmilddetergenttomaintainnish.
6.3. Lubricate the drawer slides sparingly every six months.
6.4. Stubborn grease and oil marks can be removed by using a non-abrasive cleaner.
Original Language Version
© Jack Sealey Limited
fig.2
AP6310BEIssue129/01/19
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500 01284 703534 [e-mail] www.sealey.co.uk
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
arecyclingcentreanddisposedofinamannerwhichiscompatiblewiththeenvironment.Whentheproductbecomescompletely
unserviceableandrequiresdisposal,drainanyfluids(ifapplicable)intoapprovedcontainersanddisposeoftheproductandfluids
according to local regulations.
Note:Itisourpolicytocontinuallyimproveproductsandassuchwereservetherighttoalterdata,specificationsandcomponentpartswithoutprior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty:Guaranteeis12monthsfrompurchasedate,proofofwhichisrequiredforanyclaim.
fig.4
fig.3