Sega ALL AIR TRIX DLX Reference manual

SERVICE BULLETIN
SEGA Service Department http://www.seuservice.com
45133 Industrial Drive Phone: [phone]
Fremont, Ca. 94538 Fax: [phone]
If you have any questions, please contact the SEGA Service Department at the numbers given above.
Apr 17. 2001
SPECIAL NOTICE FOR
ALL AIR TRIX DLX
PROBLEM:
SOLUTION:
Not following the directions provided herein may cause your game to malfunction.
All electrical work should be performed by the site’s Serviceman or Technician.
Stoppers, over period of time, allow too much roll motion of skateboard causing
damage to potentiometer.
Install Stopper Base ATR-3114 (4 pieces) and Sub Stopper ATR-3115 (4 pieces)
to existing stoppers.(See Following Procedure)
After Installation
Sub Stopper
Stopper Base
ATR-3114
ATR-3115
Page
1 of 4
131

PARTS REPLACEMENT PROCEDURE FOR AIR TRIX
Stopper reinforcement parts. (PHOTO 2.1)
Install these 2 parts. (SUPPLIED)
STOPPER ASE ATR-3114 4 pieces
SU STOPPER ATR-3115 4 pieces
(USE RTV SILICONE TO SECURE PARTS)
SU STOPPER
ATR-3115
STOPPER ASE
ATR-3114
ELLOWS
ROLL STOPPER
Remove the screws securing the base of bellows. Then tilt the board
up, pulling up the bellows as pictured. (PHOTO 2.2)
1
2
PHOTO 2.1
PHOTO 2.2
Page
2 of 4
131

Secure the stopper base onto stopper with a small amount of
silicone as pictured. (PHOTO 2.3)
STOPPER ASE
ATR-3114
SU STOPPER
ATR-3115
Secure the SU STOPPER onto the STOPPER ASE with a small amount of silicone, assure chamfer faces
up as shown. (PHOTO 2.4)
3
4
PHOTO 2.3
PHOTO 2.4
Page
3 of 4
131

PHOTO 2.5
PHOTO 2.6
Page
4 of 4
131
Repeat for opposite side. (Install Stopper ase &
Sub Stopper) (PHOTO 2.5)
NOTE: e careful to not get injured by the
screws, for wiring, underneath the rolling base.
(Two pieces on leftside of board.) (PHOTO 2.6)
SCREWS FOR WIRING
Route wire harness as pictured to avoid problems. (PHOTO 2.7)
PHOTO 2.7
Keep the wireharness away from
the screw head.
Reinstall all items removed by reverse.
5
6
7