SRC H-CRF300L-19-01-SL User manual

Copyright By SRC
Design and Specification are subjected to change
Page 1
Scope of Supply/Bill of Material & Mounting Drawings
Part Number: H-CRF300L-19-01-SL / H-CRF300L-19-02
Part Description: REAR COVER PUPMBRAKE –HONDA 300L

Copyright By SRC
Design and Specification are subjected to change
Page 2
Step 1:
The Rear Pump Brake, before
mounting of SRC’s Guard, We
can remove 2 original Screw in
motorbike. (As shown)
Step 2:
Orient and align the Pump Cover,
as shown, in-line with the
mounting 2 points shown in (red
colour), and slip-in the Bush –2
off, and Original Screw –2 off.
Step 3
Secure the threads in the
Mounting points and ensure the
Inside surfaces of the Pump Cover,
is not fouling with the Body of the
Rear Brake Pump.
Mounting Drawings

Copyright By SRC
Design and Specification are subjected to change
Page 3
General Information
1. We request you to pay attention to the Mounting Instructions in this document and follow the step-
by-step procedures.
2. This Mounting Instruction manual is a “Do It Yourself” (DIY) fitment manual of the Accessory part to the
Vehicle. We have prepared this based on our experience and knowledge, related to the Vehicle, Part and
its functional aspects.
3. SRC cannot guarantee the interchangeability of the parts to any other manufacturer’s accessory part. It
is advised to the User, to inspect and ensure the original state of all other Vehicle parts.
4. We request you to bear in mind, that the Installed part can change the driving behaviour and/or the
stability during driving or any other dynamic conditions.
5. If you have the appropriate tools and another person to assist you in the mounting, it will help.
6. To the maximum extent possible, our design use the current Mounting/Fitment of the Original
Equipment, so that Installation of these accessories will not affect the Payload or Function of the Vehicle or
the Part on which it is mounted to protect it
7. If any additional modifications are to be done, prior to the fitment of the accessories, it will be explicitly
specified in the instruction sheets.