SRC BMW-310GS-09-01-AL User manual

Copyright By SRC
Design and Specification are subjected to change
Page 1
Scope of Supply/Bill of Material & Mounting Drawings
Part Number: BMW-310GS-09-01-AL / BMW-310GS-09-02-AL
Part Description: Engine Guard–BMW G 310 GS
Applicable to Finished colour versions of Silver and Black
Installation / Parts List / Bill of Material for Mounting
The scope of supply from SRC for the above, will be the Aluminium Fabricated Engine Guard, as
shown below and the 4 Hexagon Nuts, for mounting.

Copyright By SRC
Design and Specification are subjected to change
Page 2
MOUNTING DRAWINGS

Copyright By SRC
Design and Specification are subjected to change
Page 3
Mounting Instruction
Step 1:
The Dirt shield which is mounted to
the Underside of the Engine, has to
be removed first, for fitment of SRC
Engine Guard
The drawing above shows, the condition,
when the Dirt Shield is removed.
It exposes the Mounting screws, already
provisioned in the Engine, for mounting the
Dirt Shield.
SRC Engine Guard, will use these Mounting
screws for fitment.

Copyright By SRC
Design and Specification are subjected to change
Page 4
Step 2:
Orient and Align the Engine Guard
with its 4 Mounting Holes, pitched
in-line with the Mounting screws
projecting out of the underside of
the Engine.
Step 3:
The Hexagon Nuts when secured and tightened to the
Projecting screws, gets flushed inside and does not
project outside. Tighten to a torque of 24-26 N-m
Final Mounted condition of the Engine Guard is as
shown.

Copyright By SRC
Design and Specification are subjected to change
Page 5
General Instructions
1. We request you to pay attention to the Mounting Instructions in this document
and follow the step-by-step procedures.
2. This Mounting Instruction manual is a “Do It Yourself” (DIY) fitment manual of the
Accessory part to the Vehicle. We have prepared this based on our experience and
knowledge, related to the Vehicle, Part and its functional aspects.
3. SRC cannot guarantee the interchangeability of the parts to any other
manufacturer’s accessory part. It is advised to the User, to inspect and ensure the
original state of all other Vehicle parts.
4. We request you to bear in mind, that the Installed part can change the driving
behaviour and/or the stability during driving or any other dynamic conditions.
5. If you have the appropriate tools and another person to assist you in the
mounting, it will help.
6. After Completion of the Mounting and before taking on a First ride, Ensure and
Check all functions of the Vehicle. It is always advised to check loosening of the
fasteners after the first 50 kilo meters of ride and at regular intervals.
7. To the maximum extent possible, our design use the current Mounting/Fitment of
the Original Equipment, so that Installation of these accessories will not affect the
Payload or Function of the Vehicle or the Part on which it is mounted to protect it
8. If any additional modifications are to be done, prior to the fitment of the
accessories, it will be explicitly specified in the instruction sheets