SRC H-CB500X-04-01-AL User manual

Copyright By SRC
Design and Specification are subjected to change
Page 1
Scope of Supply/Bill of Material & Mounting Drawings
Part Number: H-CB500X-04-01-AL / H-CB500X-04-02-AL
Part Description: Rack –HONDA CB500 X
Installation / Parts List / Bill of Material for Mounting

Copyright By SRC
Design and Specification are subjected to change
Page 2
MOUNTING DRAWINGS

Copyright By SRC
Design and Specification are subjected to change
Page 3
Step 1:
Before starting to mount the Rear Rack,
we have to unscrew the Mounting bolts
(as shown) of the Side Panel on both
sides. Since, SRC Rear Rack Mounting
Brackets (LH & RH) takes the same
mounting as that of the Side panel; it is
the first step in the Mounting process
Step 2 & 3:
Orient and align the Bracket LH (2) and
Bracket RH (4) in-line with the Side Panel
mounting holes, and bring the Side panels
exactly in-line with them, and slip-in the
Mounting bolts (2 off) on each side and
secure the threads
The drawing shown here, is the “As is
dismounted condition of the Side
panels”

Copyright By SRC
Design and Specification are subjected to change
Page 4
Ensure the Side Panels are flush
mounted on top of the Bracket LH & RH,
as shown, and the bolts tightened fully
Rear Rack as shown “Final
Assembled condition”
Step 4:
Slip in the Spacer (3) –4 off in between the
Bracket LH/RH and the Rear Rack and slip-in the
Washer M6 (6) and Screw M6 x 25 (7) through the
Mounting holes in the Rear Rack and Brackets and,
secure from the bottom, using the Nuts (M6) (8) –
4 off and tighten it to the torque as shown in the
BOM table

Copyright By SRC
Design and Specification are subjected to change
Page 5
General Instructions
1. We request you to pay attention to the Mounting Instructions in this document and follow the step-
by-step procedures.
2. This Mounting Instruction manual is a “Do It Yourself” (DIY) fitment manual of the Accessory part to
the Vehicle. We have prepared this based on our experience and knowledge, related to the Vehicle,
Part and its functional aspects.
3. SRC cannot guarantee the interchangeability of the parts to any other manufacturer’s accessory part.
It is advised to the User, to inspect and ensure the original state of all other Vehicle parts.
4. We request you to bear in mind, that the Installed part can change the driving behaviour and/or the
stability during driving or any other dynamic conditions.
5. If you have the appropriate tools and another person to assist you in the mounting, it will help.
6. After Completion of the Mounting and before taking on a First ride, Ensure and Check all functions of
the Vehicle. It is always advised to check loosening of the fasteners after the first 50 kilo meters of
ride and at regular intervals.
7. We are showing here the Scope of Supply/ Installation/Parts list & BOM from SRC
8. To the maximum extent possible, our design use the current Mounting/Fitment of the Original
Equipment, so that Installation of these accessories will not affect the Payload or Function of the
Vehicle or the Part on which it is mounted to protect it
9. If any additional modifications are to be done, prior to the fitment of the accessories, it will be
explicitly specified in the instruction sheets.