SRC H-CRF250L-02-01-SL User manual

Copyright By SRC
Design and Specification are subjected to change
Page 1
No. Description Quantity Torque * (N-m) Remarks **
1 Radiator Guard 1
2 Bush Pipe 2
3 Washer M6 2
4 Cap Screw M6 2 15
SRC Design uses Metric System of Measurement and all dimensions are in Millimeters
* Recommended to use the Torque specified in the table
** Denotes Usage of Liquid Thread Locker in specified locations
Scope of Supply/Bill of Material & Mounting Drawings
Part Number: H-CRF250L-02-01-SL / H-CRF250L-02-02
Part Description: Radiator Guard –HONDA CRF250 L
Installation / Parts List / Bill of Material for Mounting

Copyright By SRC
Design and Specification are subjected to change
Page 2
MOUNTING DRAWINGS

Copyright By SRC
Design and Specification are subjected to change
Page 3
Mounting Instructions
Step 1:
Step 1: Remove the Dirt Shield
(OE Part), mounting screws and
keep the Dirt shield aside, before
starting to mount SRC Radiator
Guard
Step 2:
Remove the two Mounting bolts
(Shown in “Red” colour), which
holds the Radiator to the Chassis
frame and slip-in the Long Bush
Pipe (2) –2 off, Orient the
Radiator Guard’s Far end
mounting holes, as shown in the
drawing and slide-in the Washer
M6 (3) –2 off and the Long Cap
Screw M6 through the Bush
pipe, and secure the threads,
and tighten it fully.

Copyright By SRC
Design and Specification are subjected to change
Page 4
Step 4:
Align the Dirt Shield, as shown, in-line
with the Mounting holes and slip-in
the OE Bolts and secure the threads
and tighten it fully.
Step 3:
Radiator Guard in “As is so far”
mounted condition is shown in the
drawing

Copyright By SRC
Design and Specification are subjected to change
Page 5
Step 5:
The Final Mounted condition of the
SRC Radiator Guard, with Dirt Shield
mounted back, is as shown in the
drawing.