SRC Y-900GT-14-01-SL User manual

Copyright By SRC
Design and Specification are subjected to change
Page 1
NO. Description Quantity Torque * (N-M) Remarks ** Check List
4
49 - 10
1
1
1
1
2
3
4
5
Bottom Plate
Top Plate
Middle Plate
Use LiquidThread Locker
Nut M6
SRCDesign uses MetricSystem of Measurement and all dimensions in Millimeters
*Recommended to use the Torque specified in the table
**Denotes Usage of Liquid Thread Locker in specified Locations
Countersink Screw M6 X 16
Scope of Supply/Bill of Material & Mounting Drawings
Part Number: Y-900GT-14-01-SL / Y-FJ09-14-01-SL
Part Description: Large Side Stand –YAMAHA TRACER 900 GT / FJ-09 / MT-09 TRACER
Installation / Parts List / Bill of Material for Mounting

Copyright By SRC
Design and Specification are subjected to change
Page 2
MOUNTING DRAWINGS

Copyright By SRC
Design and Specification are subjected to change
Page 3
Step 1:
During Mounting the Large Side Stand,
let the Motorbike firmly rest on the
floor, using the Centre Stand.
The side stand can be brought forward
(position as shown in the drawing) to
have access to the Mounting/ Assembly
of the SRC Large Side Stand.
Step 2:
Orient and Slip-in the Middle Plate
(2), as shown.
The peripheral Inner walls of the
Middle plate, will closely hug the
outer walls of the Side stand.
Step 3:
Orient the Bottom Plate (1), in-line with the Mounting
Holes on the Middle Plate and slide-in the M6 Screws
(4) from the bottom side.

Copyright By SRC
Design and Specification are subjected to change
Page 4
Step 4:
Slide-in the Top Plate (3), as shown and orient the
mounting holes in-line with the 4 Projecting screws.
Step 5:
Secure the threads on the screw using M6 Nut (5), as
shown.
As shown in the left, is the Final Mounted condition of
the Side Stand

Copyright By SRC
Design and Specification are subjected to change
Page 5
General Instructions
1. We request you to pay attention to the Mounting Instructions in this document and
follow the step-by-step procedures.
2. This Mounting Instruction manual is a “Do It Yourself” (DIY) fitment manual of the
Accessory part to the Vehicle. We have prepared this based on our experience and knowledge,
related to the Vehicle, Part and its functional aspects.
3. SRC cannot guarantee the interchangeability of the parts to any other manufacturer’s
accessory part. It is advised to the User, to inspect and ensure the original state of all other
Vehicle parts.
4. We request you to bear in mind, that the Installed part can change the driving
behaviour and/or the stability during driving or any other dynamic conditions.
5. If you have the appropriate tools and another person to assist you in the mounting, it
will help.
6. After Completion of the Mounting and before taking on a First ride, Ensure and Check
all functions of the Vehicle. It is always advised to check loosening of the fasteners after the
first 50 kilo meters of ride and at regular intervals.
7. We are showing here the Scope of Supply/ Installation/Parts list & BOM from SRC
8. To the maximum extent possible, our design use the current Mounting/Fitment of the
Original Equipment, so that Installation of these accessories will not affect the Payload or
Function of the Vehicle or the Part on which it is mounted to protect it
9. If any additional modifications are to be done, prior to the fitment of the accessories,
it will be explicitly specified in the instruction sheets.