SRC BMW-F750GS-04-01-AL User manual

Copyright By SRC
Design and Specification are subjected to change
Page 1
Scope of Supply/Bill of Material & Mounting Drawings
Part Number: BMW-F750GS-04-01-AL / BMW-F750GS-04-02-AL
Part Description: Rack –BMW F 750 GS
Installation / Parts List / Bill of Material for Mounting

Copyright By SRC
Design and Specification are subjected to change
Page 2
MOUNTING DRAWINGS

Copyright By SRC
Design and Specification are subjected to change
Page 3
Step 1 :
The Non-ferrous Top plate, over which
SRC Top Rack will be mounted, is as
shown in the drawing.
It has the 4 mounting hole provision, to
mount and fit the SRC top Rac.
Step 2:
Orient and Align the Top Rack (1) in-line with the 4
Mounting holes on the Non-ferrous Top plate and Slip-
in the Spacer (3) –4 off, between the underside of the
Top Rack and the Top plate, as shown.
Also, slide-in the M6 Countersink Washer (2) –4 off
and M6 x 45 Screw (4) –4 off, in-line with the above
mounting holes.
Mounting Instructions

Copyright By SRC
Design and Specification are subjected to change
Page 4
Step 3:
Tighten the Screws, flushing with the countersink washers and secure the threads in
the top plate, as shown in the above drawing.
Ensure Orientation and tighten it to torque, as per specifications in the BOM table.
The Top Rack, in final mounted condition, is as shown in the above drawing.

Copyright By SRC
Design and Specification are subjected to change
Page 5
General Instructions
1. We request you to pay attention to the Mounting Instructions in this document and follow
the step-by-step procedures.
2. This Mounting Instruction manual is a “Do It Yourself” (DIY) fitment manual of the
Accessory part to the Vehicle. We have prepared this based on our experience and
knowledge, related to the Vehicle, Part and its functional aspects.
3. SRC cannot guarantee the interchangeability of the parts to any other manufacturer’s
accessory part. It is advised to the User, to inspect and ensure the original state of all
other Vehicle parts.
4. We request you to bear in mind, that the Installed part can change the driving behaviour
and/or the stability during driving or any other dynamic conditions.
5. If you have the appropriate tools and another person to assist you in the mounting, it will
help.
6. After Completion of the Mounting and before taking on a First ride, Ensure and Check all
functions of the Vehicle. It is always advised to check loosening of the fasteners after the
first 50 kilo meters of ride and at regular intervals.
7. We are showing here the Scope of Supply/ Installation/Parts list & BOM from SRC
8. To the maximum extent possible, our design use the current Mounting/Fitment of the
Original Equipment, so that Installation of these accessories will not affect the Payload or
Function of the Vehicle or the Part on which it is mounted to protect it
9. If any additional modifications are to be done, prior to the fitment of the accessories, it
will be explicitly specified in the instruction sheets.