SRC Royal Enfield Himalayan User manual

Copyright By SRC
Design and Specification are subjected to change
Page 1
Scope of Supply/Bill of Material & Mounting Drawings
Part Number: R-HM18-02-01SL / R-HM18-02-02
Part Description: Oil Cooler Cover - Royal Enfield Himalayan
Installation / Parts List / Bill of Material for Mounting

Copyright By SRC
Design and Specification are subjected to change
Page 2
Mounting Instructions
Step 2:
Mounting of Oil Cooler Guard Front
Side (1) Orient the Mounting Holes of
Oil Cooler Guard FS (Front Side) (1),
in-line with
the Mounting holes in
the Motorbike, and slide in the
Washer M6 (4) - 2 off and Screw M6
x 25 (6) –2 off and secure the
threads, but do not tighten it fully.
For Mounting the Oil Cooler Guard, we
use the Mounting Holes (as identified in
“Red colour” in the two drawings.
Step 1:
Remove the original Radiator Guard and
the original Screw in motorbike.

Copyright By SRC
Design and Specification are subjected to change
Page 3
The final mounted condition of the Oil Cooler
Guard is as shown in the adjacent drawing .
Step 3:
Orient the Oil Cooler Guard Rear
Side (RS) (2).
Slide in the Bush spacer Delrin (3)
–2 off, sandwiching between the
adjacent surfaces and Slide in the
M6 washer (4)-1 off, and Screw
M6x20 (5)-1 off, The Oil Cooler FS
has the threaded hole to secure
the threads of the M6 screw.
Step 3:
Orient the Nut M6 (7) -1 off
Slide in the Nut M6 (7) –1 off, to
the Oil Cooler Guard Rear Side (RS)
(2). has the threaded hole to secure
the threads of the M6 screw.

Copyright By SRC
Design and Specification are subjected to change
Page 4
General Instructions
1. We request you to pay attention to the Mounting Instructions in this document and follow
the step-by-step procedures.
2. This Mounting Instruction manual is a “Do It Yourself” (DIY) fitment manual of the
Accessory part to the Vehicle. We have prepared this based on our experience and knowledge,
related to the Vehicle, Part and its functional aspects.
3. SRC cannot guarantee the interchangeability of the parts to any other manufacturer’s
accessory part. It is advised to the User, to inspect and ensure the original state of all other
Vehicle parts.
4. We request you to bear in mind, that the Installed part can change the driving behaviour
and/or the stability during driving or any other dynamic conditions.
5. If you have the appropriate tools and another person to assist you in the mounting, it will
help.
6. After Completion of the Mounting and before taking on a First ride, Ensure and Check all
functions of the Vehicle. It is always advised to check loosening of the fasteners after the first
50 kilo meters of ride and at regular intervals.
7. We are showing here the Scope of Supply/ Installation/Parts list & BOM from SRC
8.To the maximum extent possible, our design use the current Mounting/Fitment of the
Original Equipment, so that Installation of these accessories will not affect the Payload or
Function of the Vehicle or the Part on which it is mounted to protect it
9.If any additional modifications are to be done, prior to the fitment of the accessories, it
will be explicitly specified in the instruction sheets.