SRC Y-T700-09-01-AL User manual

Copyright By SRC
Design and Specification are subjected to change
Page 1
Scope of Supply/Bill of Material & Mounting Drawings
Part Number: Y-T700-09-01-AL / Y-T700-09-02
Part Description: Engine Guard–YAMAHA TENERE 700
Applicable to Finished colour versions of Silver and Black
Installation / Parts List / Bill of Material for Mounting

Copyright By SRC
Design and Specification are subjected to change
Page 2
MOUNTING DRAWINGS

Copyright By SRC
Design and Specification are subjected to change
Page 3
Mounting Instructions
Step 1:
Remove the Cover already installed in
the Motorbike. This will allow access to
the Mounting Holes for fitment of SRC
Engine Guard
Step 2:
Mounting of Rear End Bracket (2)
Orient the Rear End Bracket, as shown,
through the holes as shown, and secure
the threads, using the Screw M8x30 (4)
2 off, and the washer M8 (6) 2 off, and
secure the threads in the Motobike.

Copyright By SRC
Design and Specification are subjected to change
Page 4
Step 3:
Repeat the Step 2 similarly for mounting
the Bracket (2) from the Right-hand side,
as shown.

Copyright By SRC
Design and Specification are subjected to change
Page 5
General Instructions
1. We request you to pay attention to the Mounting Instructions in this document and follow the step-by-
step procedures.
2. This Mounting Instruction manual is a “Do It Yourself” (DIY) fitment manual of the Accessory part to the
Vehicle. We have prepared this based on our experience and knowledge, related to the Vehicle, Part and
its functional aspects.
3. SRC cannot guarantee the interchangeability of the parts to any other manufacturer’s accessory part. It
is advised to the User, to inspect and ensure the original state of all other Vehicle parts.
4. We request you to bear in mind, that the Installed part can change the driving behaviour and/or the
stability during driving or any other dynamic conditions.
5. If you have the appropriate tools and another person to assist you in the mounting, it will help.
6. After Completion of the Mounting and before taking on a First ride, Ensure and Check all functions of
the Vehicle. It is always advised to check loosening of the fasteners after the first 50 kilo meters of ride and
at regular intervals.
7. To the maximum extent possible, our design use the current Mounting/Fitment of the Original
Equipment, so that Installation of these accessories will not affect the Payload or Function of the Vehicle or
the Part on which it is mounted to protect it
8. If any additional modifications are to be done, prior to the fitment of the accessories, it will be explicitly
specified in the instruction sheets