Steelcase c:scape User manual

Page 1 of 2
939549927 Rev F
If you have a problem, question, or request, call
your local dealer, or Steelcase Line 1 at
888.STEELCASE (888.783.3522)
for immediate action by people who want to help you.
(Outside the U.S.A., Canada, Mexico, Puerto Rico,
and the U.S. Virgin Islands, call: 1.616.247.2500)
Or visit our website: www.steelcase.com
©2014 Steelcase Inc.
Grand Rapids, MI 49501
U.S.A.
Printed in U.S.A.
BEAM
1
DESKING
4
MID STORAGE
3
LOW STORAGE
5
PRIVACY
6
Furniture should be installed in sequence shown below.
THIS INSTALLATION SEQUENCE IS HERE.
POWER
2
c:scape™Receptacles - Desk, Base or Storage
DECORATIVE
FACEPLATE
Desk Receptacle
Attach any chosen receptacle into the desk power block, by
pushing in (a) then sliding over into the mating contacts (b).
The receptacle will lock into place. Attach decorative
faceplate around the receptacle (c).
b
c
a
RECEPTACLE
FLEX RECEPTACLE
OR
NOTE: Unused modular electrical
connector openings are not
required to be capped.
NOTE: This equipment has been tested and
found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable
protection against harmful interface when the
equipment is operated in a commercial environment.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instruction manual, may cause
harmful interference to radio communications.
Operation of this equipment in a residential area is
likely to cause harmful interference in which case
the user will be required to correct the interference
at his own expense.
OR
USB RECEPTACLE

b
b
c
DECORATIVE
FACEPLATE
c
RECEPTACLE
COVER
Page 2 of 2
939549927 Rev F
Base Receptacle
Remove receptable cover (a). Attach any chosen receptacle into the base
power block, by pushing in (b) then sliding over into the mating contacts (c).
The receptacle will lock into place. Attach decorative faceplate around the
receptacle (d).
Storage Receptacle
Attach any chosen receptacle into the storage power block, by
pushing in (a) then sliding over into the mating contacts (b).
The receptacle will lock into place. Attach decorative faceplate
around the receptacle (c).
a
OR
RECEPTACLE
RECEPTACLE
DECORATIVE
FACEPLATE
FLEX RECEPTACLE
d
FLEX RECEPTACLE
OR
a