Steelcase Migration Bench SE User manual

Migration Bench SE
User Guide

RISK OF SERIOUS INJURY
If not used as intended, moving worksurfaces can pinch and cause
injury or property damage.Always follow these instructions:
1. Keep height-adjustment range free from obstructions above
and below the worksurface.
2. Plan for a minimum 1" gap to adjacent furniture.
This powered, height-adjustable desk appliance is not
intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person
responsible for their safety. Children should be supervised to
ensure that they do not play with the appliance. This appliance is
only to be used with the power supply unit provided with the
appliance.

Standard Handset –Up/Down Controls
Manual Guide
Upgraded Handset –4 Memory Preset
Programming Memory Presets
1. Press the up or down arrow to set the worksurface to the desired height.
2. Press “M” button followed by one of the preset number buttons (1,2 or 3) on
the LED screen.
3. The table will automatically reset to this height whenever the preset number
is pressed and held* until the preset height is reached.
Power Saving Mode –Waking up the Hand Set
1. Press any button to wake up handset.
Resetting the Base
! Note: Make sure there is nothing under the base before setting to its lowest
22.5” or 57.1cm. If the cable is obstructed it will not reset properly.
1. Press and hold the Down arrow; the desk will begin to go down.
2. Once the desk reaches its lowest height, continue to press the Down arrow
for 5 seconds, until the digital display shows “RST”.
3. Release and then press the Down arrow again; the recalibration process will
now begin.
4. When reset is complete, the digital display will show 22.5” or 57.5cm.
A. Up Button
B. Down Button
A. Height Adjustment Buttons
B. Memory Position Buttons
C. Memory Setting Buttons
D. Digital Display

Most issues will resolve by re-setting the base
See re-set instructions on previous page.
! Note: Make sure there is nothing under the base before setting to its lowest
level (2-Stage 28”, 3-Stage-22.5”) If the cable is obstructed it will not reset
properly
Trouble shooting guide
!Please ensure that all connections area tight and in tact before further troubleshooting.
Issue Solution
ASR/RST Error Code Reset the base.
No power/LED on control box
is off The control box may be damaged-contact us for replacement.
E07/E08 Error Code (legs not
moving uniformly) 1. Reset the base. 2. If the issue persists, swap the connecting cables.
3. If the issue persists, contact us for a replacement.
H01 Error Code (Controller
Overheat) Disconnect the power for 1 minute and then reconnect the handset.
Handset Display Error (eg.
“88.8”)
The handset may be damaged-contact us for replacement.
For questions and support, please contact Steelcase Customer Care.
Please ensure that all connections area tight before further troubleshooting.
Issue Solution
Base is not moving or
operates irregularly. 1. Make sure that all connections are intact and that the outlet has power.
2. Once connection are verified, reset the base.
3. If the issue persists, please contact our Customer Care.
Base Stops and can only
move downwards. 1. Base might be overloaded. 2. Remove some of the weight on the work surfaces and
try again.
3. If the issue persists, please contact customer service.
Movement only in one leg. 1. Make sure that all the connections are intact and the
outlet has power.
2. Once connections are verified, reset the base.
3. If the issue persists, please contact customer service.