STI STI-SA5500 User manual

INSTALLATION OF STI-SA5500 SELECT ALERT SIREN/STROBE
All specifications and information shown were current as of publication and are subject to change without notice.
SA5500IS MARCH2019
2306 Airport Road • Waterford, Michigan 48327-1209
Phone: [phone] • Fax: [phone]
Toll Free: 800-888-4784 • E-mail: [email protected]
Web: www.sti-usa.com
Taylor House • 34 Sherwood Road • Bromsgrove
Worcestershire • B60 3DR • England
Tel: [phone] • Fax: [phone]
E-mail: [email protected] • Web: www.sti-emea.com
BATTERY INSTALLATION/REPLACEMENT
1. Unscrew lens to remove.
2. Loosen PCB screws (do not remove).
3. Gently rotate PCB without touching LED’s and
without damaging the reflectors.
4. Connect battery and slide under retainer.
5. Re-install PCB and tighten screws.
NOTES
1. Internal battery will provide backup power if loss of external power.
2. If no internal battery is used, remove all power and move S2-1 to
“OFF” position (see detail S2).
LOW BATTERY OPERATON
Replace battery when low battery condition occurs,
Low battery LED flashes 1x per 1 minute and sounder
beeps 1x per 3 minutes
WARNING: This product can expose you to chemicals including Dichloromethane, which is
known to the State of California to cause cancer, and Bisphenol A (BPA), which is known to the
State of California to cause birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
Three year warranty or a one year limited warranty (from date of purchase) on most products.
See website for details. Electronic warranty form at www.sti-usa.com/wc14.
AIL A
LE 5 : 1
A
B
PCB SCREWS
9 VDC BATTERY (NOT INCLUDED)
9 VDC BATTERY CONNECTOR
CIRCUIT BOARD
LENS
LENS
#6 x 2 1/2 in. SCREW
(2) PROVIDED
O-RING (2) PROVIDED
ELECTRONIC BASE
DRILL 3/16 DIA. HOLES
1 1/4 in. DEEP WHEN USING ANCHORS
DRILL 7/64 DIA. HOLES 1 1/4 in. DEEP
WHEN ANCHORS ARE NOT USED
#8-10 WALL ANCHOR (2) PROVIDED
S1 S2
REFLECTORS
LOW BATTERY
LED
FLASH RATE ADJUSTMENT
AIL A
LE 5 : 1
A
B
PCB SCREWS
9 VDC BATTERY (NOT INCLUDED)
9 VDC BATTERY CONNECTOR
CIRCUIT BOARD
LENS
LENS
#6 x 2 1/2 in. SCREW
(2) PROVIDED
O-RING (2) PROVIDED
ELECTRONIC BASE
DRILL 3/16 DIA. HOLES
1 1/4 in. DEEP WHEN USING ANCHORS
DRILL 7/64 DIA. HOLES 1 1/4 in. DEEP
WHEN ANCHORS ARE NOT USED
#8-10 WALL ANCHOR (2) PROVIDED
S1 S2
REFLECTORS
LOW BATTERY
LED
FLASH RATE ADJUSTMENT
AIL A
LE 5 : 1
A
B
PCB SCREWS
9 VDC BATTERY (NOT INCLUDED)
9 VDC BATTERY CONNECTOR
CIRCUIT BOARD
LENS
LENS
#6 x 2 1/2 in. SCREW
(2) PROVIDED
O-RING (2) PROVIDED
ELECTRONIC BASE
DRILL 3/16 DIA. HOLES
1 1/4 in. DEEP WHEN USING ANCHORS
DRILL 7/64 DIA. HOLES 1 1/4 in. DEEP
WHEN ANCHORS ARE NOT USED
#8-10 WALL ANCHOR (2) PROVIDED
S1 S2
REFLECTORS
LOW BATTERY
LED
FLASH RATE ADJUSTMENT
AIL A
LE 5 : 1
A
B
PCB SCREWS
9 VDC BATTERY (NOT INCLUDED)
9 VDC BATTERY CONNECTOR
CIRCUIT BOARD
LENS
LENS
#6 x 2 1/2 in. SCREW
(2) PROVIDED
O-RING (2) PROVIDED
ELECTRONIC BASE
DRILL 3/16 DIA. HOLES
1 1/4 in. DEEP WHEN USING ANCHORS
DRILL 7/64 DIA. HOLES 1 1/4 in. DEEP
WHEN ANCHORS ARE NOT USED
#8-10 WALL ANCHOR (2) PROVIDED
S1 S2
REFLECTORS
LOW BATTERY
LED
FLASH RATE ADJUSTMENT
DETAIL S1
See pg. 2
DETAIL S2
3.73 in.
(94.6 mm)
.94 in.
(23.8 mm)
2.83 in.
(71.8 mm)
1.02 in.
(26.0 mm)
3.87 in.
( 98.2 mm)
3.73 in.
(94.6 mm)
.94 in.
(23.8 mm)
2.83 in.
(71.8 mm)
1.02 in.
(26.0 mm)
3.87 in.
( 98.2 mm)
1 2 3 4 FUNCTION
1 LOW BATTERY NOTIFICATION ON
* 0 LOW BATTERY NOTIFICATION OFF
* 0 0 0 RIGHT ROTATION
0 0 1 SINGLE LED ROTATION
0 1 0 BREATHING
0 1 1 FLASHING
1 0 0 ROTATION
1 0 1 INDIRECT FLASHING
1 1 0 DOUBLE LED ROTATION
1 1 1 CONTINUOUS
S2 - LOW BAT. NOTIFICATION/STROBE CONTROL
1 2 3 4
1 ON
0 OFF
*Default Settings
SPECIFICATION
Input Standby Operating
9VDC < 14µA 0.95A
12VDC < 180µA 0.96A
24VDC < 170µA 0.49A
Operating Temperature
-4°F to 104°F (-20°C to 40°C)

2306 Airport Road • Waterford, Michigan 48327-1209
Phone: [phone] • Fax: [phone]
Toll Free: 800-888-4784 • E-mail: [email protected]
Web: www.sti-usa.com
Taylor House • 34 Sherwood Road • Bromsgrove
Worcestershire • B60 3DR • England
Tel: [phone] • Fax: [phone]
E-mail: [email protected] • Web: www.sti-emea.com
BLK (-)
RED (+)
9VDC
YEL
+
-
BLU
STROBE & SIREN
TRIGGER
(NOT PROVIDED)
BLK (-)
RED (+)
9VDC
YEL
+
-
BLU
TRIGGER
(NOT PROVIDED)
BLK (-)
RED (+)
9VDC
YEL
+
-
BLU
TRIGGER
(NOT PROVIDED)
SIREN ONLY
STROBE ONLY
Control with Power Supply
-Not supervised
- Alarm on close
- Cannot use battery
turn off Low Battery Detect
YEL
RED (+)
9VDC
BLU
-
+
BLK (-)
STROBE & SIREN
TRIGGER
(NOT PROVIDED)
YEL
RED (+)
9VDC
BLU
-
+
BLK (-)
SIREN ONLY
TRIGGER
(NOT PROVIDED)
YEL
RED (+)
9VDC
BLU
-
+
BLK (-)
STROBE ONLY
TRIGGER
(NOT PROVIDED)
Power Supply Plus Battery
- Supervised trigger
- Alarm on open trigger
- Low battery alert
(Turn off if battery not used)
RED (+)
YEL
9VDC
BLU
BLK (-)
STROBE & SIREN
TRIGGER
(NOT PROVIDED)
RED (+)
YEL
9VDC
BLU
BLK (-)
SIREN ONLY
TRIGGER
(NOT PROVIDED)
RED (+)
YEL
9VDC
BLU
BLK (-)
STROBE ONLY
TRIGGER
(NOT PROVIDED)
Battery Only
- Supervised trigger
- Alarm on open
trigger
- Low battery alert
INSTALLATION OF STI-SA5500 SELECT ALERT SIREN/STROBE
All specifications and information shown were current as of publication and are subject to change without notice.
SA5500IS MARCH2019
SIREN
STROBE
S1 ALARM TONES
1 2 3 4 5 FUNCTION
* 1 1 1 1 1 2400Hz - 2900Hz @ 3 Hz
O 1 1 1 1 970Hz, 0.5s ON/0.5s OFF x 3/1.5s OFF (ISO 8201)
1 O 1 1 1 554Hz, 0.1s/440Hz, 0.4s (AFNOR NF S 32 001)
O O 1 1 1 420Hz 0.625s ON/0.625s OFF (AUSTRALIA AS1670 ALERT TONE)
1 1 O 1 1 800Hz - 970Hz @ 3Hz
O 1 O 1 1 660Hz 0.15s ON/0.15s OFF
1 O O 1 1 550Hz, 0.7s/1000Hz, 0.33s
O O O 1 1 510Hz, 0.25s/ 610Hz, 0.25s
1 1 1 O 1 800Hz - 970Hz @ 9Hz
O 1 1 O 1 2400Hz
1 O 1 O 1 250Hz - 1200Hz @ 12Hz
O O 1 O 1 500Hz - 1200Hz @ 0.33Hz
1 1 O O 1 660Hz 1.8s ON/1.8s OFF
O 1 O O 1 2850Hz, 0.5s ON/0.5s OFF x 3/1.5s OFF (ISO 8201)
1 O O O 1 1000-2500Hz, 0.5s/ 0.5s OFF x 3/1.5s OFF (AS1670 EVACUATION)
O O O O 1 800Hz - 970Hz @1Hz
1 1 1 1 O 500Hz - 1200Hz, 3.5s ON/ 0.5s OFF (NEN 2575:2000 DUTCH SLOW WHOOP)
O 1 1 1 O 970Hz, 1s OFF/1s ON
1 O 1 1 O 970Hz
O O 1 1 O 750Hz
1 1 O 1 O 2400Hz - 2900Hz @ 9 Hz
O 1 O 1 O 800Hz, 0.25s ON/ 1s OFF
1 O O 1 O 800Hz / 970Hz @2Hz
O O O 1 O 1500Hz - 2700Hz @ 3Hz
1 1 1 O O 800Hz / 1000Hz 0.5s each (1Hz)
O 1 1 O O 970Hz, 0.5s/ 630Hz, 0.5s
1 O 1 O O 550Hz/440Hz @ 0.5 Hz
O O 1 O O 500Hz - 1200Hz, 3.75s ON / 0.25s OFF (AS2220)
1 1 O O O 1200Hz - 500Hz @ 1Hz (DIN 33 404)
O 1 O O O 520Hz, 0.5s / 0.5s OFF x 3/1.5s OFF (FIRE)
1 O O O O 500Hz - 1200Hz, 0.5s/ 0.5s OFF x 3/1.5s OFF (AS1670 EVACUATION)
O O O O O 1800Hz - 3300Hz @ 150ms
S1 VOLUME
6 FUNCTION
* 1 High volume
0 Low volume
1 2 3 4 5 6
1 ON
0 OFF
*Default Settings