
8
and 5 in
a. Using your Awning, measure the distance
from the right end of the Square Bar to the
inner and outer edges of the right Arm Clamp
and record those measurements.
b.
Clamp.
c.
and 4 in
Step 4.
AREA IN WHICH EACH BRACKET MUST BE INSTALLED
or a door, use these steps to locate the studs inside
your home and transfer those measurements to the
outside. Get a roll of duct tape or similar tape. From
inside your home on the wall that your Awning will
the tape or door to the center of the stud, and write
On the outside wall, using the inside measurements,
line.
CAUTION: PROPER LOCATION OF THE BRACKETS IS
THE MOST IMPORTANT ASPECT OF THE AWNING
MOUNTING. IT IS CRITICAL THAT YOU FASTEN
BOTH LAG SCREWS IN EACH MOUNTING BRACKET
STRUCTURAL MEMBERS.
it easier to insert the pre-assembled Awning into the
WARNING: FAILURE TO PROPERLY AND SECURELY
FASTEN BOTH LAG SCREWS IN EACH WALL BRACKET
TO THE STRUCTURE COULD RESULT IN THE COLLAPSE
OF THE AWNING AND CAUSE PERSONAL INJURY.
ALL
wide Awning, install supplied at
f.
wide Awnings, install
f.
wide Awnings, install
afg.
wide Awnings, install
aefg
See .
.
- Between the two Arms,
.
- On the nearest stud about 2’ from the
- On the nearest stud to the middle point
- On the nearest stud about 2’ from the
middle point of the Awning, toward the right.
- Between the two Arms,
.
- Between the right end of the Awning and
the right Arm, .