Target CAPRI User manual

COMPONENTS / HARDWARE
2
ALLOW 30 MINUTES
FOR ASSEMBLY 2 PEOPLE REQUIRED
FOR ASSEMBLY
IMPORTANT:
On initial assembly, DO NOT tighten bolts
completely until all parts are joined. Once
all parts are joined,
flip table over, ensure all legs are even.
Once even, tighten bolts.
CAPRI COFFEE TABLE 120X60CM
PRE-ASSEMBLY PREPARATION
BEFORE YOU START
1.Choose a clean, level, spacious assembly area.
2.Avoid hard surfaces that may damage the product.
3.Check and ensure you have all required contents for complete assembly.
4.Always read the assembly instructions carefully before beginning.
5.The packaging and contents can be a choking hazard, therefore keep out of
reach of small children at all time.
6.Do not over tighten bolts as this may damage the thread.
A
G
FED
C
B
PRODUCT IMAGE
1PC 4PCS 1PC
20PCS M6*20 20PCS 20PCS
1PC

2
FINISH
STEP 3: STEP 4:
STEP 1: STEP 2:
PLACE THE TABLE TOP UPSIDE DOWN ON A FLAT,SOFT SURFACE.
ALIGN HOLES IN PART (B) OVER THREADS IN PART(A).
ATTACH PART(B) TO PART(A) .USING BOLTS AS SHOWN BELOW .
DO NOT COMPLETELY TIGHTEN BOLTS AT THIS POINT
ALIGN HOLES IN PART(C) WITH THREADS IN PART(B).
ATTACH PART(C ) TO PART(B).USING BOLTS AS SHOWN BELOW .
DO NOT COMPLETELY TIGHETEN BOLTS AT THIS POINT
FLIP TABLE OVER, ENSURE ALL LEGS ARE EVEN. ONCE EVEN, COMPLETELY
TIGHTEN ALL BOLTS AND COVER BOLT HEADS WITH CAP(F).
BE CAREFUL NOT TO OVERTIGHTEN AS THIS MAY DAMAGE THREADS.
.
YOUR TABLE IS NOW READY FOR USE.