teko Astra-531 AC Installation instructions

Astra-531 Ver.AC
Acoustic Surface Glass Break
Detector
User Instruction*
Sales:
Controlex GmbH
Philosophenweg 31-33
47051 Duisburg,Germany
+49 (0) 203/393 91 188
[e-mail]
www.controlex.eu
Warranty service and
technical support:
TEKO-TD
Prospekt Pobedy str. 19
420138 Kazan, Russia
[phone]
[email protected]z
www.teko.biz
Made in Russia
Rev. 531-akv1_0_instr_EN
1 FUNCTION
The detector is designed to detect destruction
of glasses, glazed structures of enclosed area
and generate an alarm notification by opening
of signaling relay contacts.
2 DETECTION ZONE
3 SPECIFICATIONS
Maximal detection range, m............................ 6
Operating frequencies:
first, Hz ..............................................6000±100
second, Hz.............................................150±10
Power supply voltage, V..................from 8 to 15
Current consumption, mA, max......................18
Overall dimensions, mm.....................62×37×29
Operating Conditions
Temperature range, °С............from - 20 to + 50
Relative air humidity, % .........up to 95 at + 35 °С
Without moisture condensation
4 DELIVERY SET
Delivery set contains holders and fasteners
(dowel –2 pcs., screw –2 pcs.).
5 OPERATING MODE
Operating mode
Plug
name
Jumper
position
High sensitivity of
AC-channel
Normal sensitivity
of
AC-channel
GB
“Alarm memory”
ON
“Alarm memory”
OFF
Mem
AC-channel test
Mem
See par. 9
6 INSTALLATION LOCATION
1) Recommended installation height is at least
2m and at a distance not more than 6m from
the most distant spot of protected glass.
2) Installation on ceiling, on a wall, in window
openings and between window frames is al-
lowed.
3) The detector cannot be used in premises
with high level of acoustic interference.
4) Alarm loop and power supply wires should
be located far from power cables.

To eliminate false alarm hazards
1) It is recommended close doors and vents,
switch off fans, loud-speakers and other possi-
ble sources of acoustic interference in the room
during protection period.
2) The detector's location should provide di-
rect visibility of all secured glass parts; masking
the detector with decorative curtains is not al-
lowed, as sensitivity may be lost.
Not recommended installation locations
7 INSTALLATION PROCEDURE
1) Remove cover
2) Remove PCB
3) Install on the wall.
Detector base
should be
positioned strictly
as per figure!
There is a possibility to install detector using a
bracket (delivered separately).
4) Replace PCB and
perform wiring
(see par.8)
5) Perform AC-channel
testing (see par.9)
8 WIRING
Perform wiring to detector`s terminals in
accordance with control panel operating
manual.
RELAY –terminals for detector connection to
alarm loop;
TMP –detector tampering control terminals;
GND, +12V –power supply terminals.
9 AC-CHANNEL TEST
1) Install jumper on Mem plug.
2) Power detector ON. LED starts flash during
60 sec.
3) During this time
remove jumper from
Mem plug.AC-
channel TEST
mode switches for
8 min.
4) Close detector.
5) Apply non-
destructive strike
to the most distant part of the protected glass.
6) At the detection moment the LED should
light up for 4s and relay shouldopen (check
with control panel)or LED flashes twice.
10 WARRANTY
The operation warranty period is 5 years from the date
of operation start-up but no longer than 5 years 6
months from the date of manufacturing subject to the
requirements of Operating Manual.
*For more detailed information refer to detector
Operating Manual available for free from
www.controlex.eu.
Hooks