teko Astra-531 User manual

Astra-531 ver. DC
Dual channel detector
User guide
Manufacturer:
ZAO NTC TEKO
420108 Kazan, Russia
Gafuri 71
[phone]
[email protected]
www.teko.biz
Made in Russia
rev. 531-smv1_6_instr_en
1 FUNCTION
Detector is intended to detect unauthorized
access into closed protected area and to
generate an alarm notification by opening
signaling relay output contacts.
2 DETECTION ZONES
3 SPECIFICATIONS
Range of detectable
moving speed, m/sec.............from 0.3 up to 3.0
Power supply voltage, V.............from 8 up to 15
Current consumption, mA, max......................18
Overall dimensions, mm.....................62×37×29
Operating Conditions
Temperature range, °С....... from - 30 up to + 55
Relative air humidity, %........... up to 98 at +25 °С
without moisture condensation
4 DELIVERY SET
Delivery set includes: dowel - 2 pcs., screw - 2 pcs.,
bracket –1 pc.
5 INSTALLATION PLACE
1) Recommended installation height 2,5-3,5 m
and a distance of 6 m to the most distant point of
the secured window.
2) It is possible to install the detector on a ceiling,
wall,andwindowholes.
3) It is not allowed to operate the detector in a
room with a high levelof soundinterference.
To eliminate false alarms
1) In the room for the period of protection,
close doors, vents, turn off possible sources of
strong air currents (fans, air conditioners) and
sound interference (broadcast loudspeakers,
etc.).
2) All sections of the protected glass must be
within the line of sight of the detector; it is pro-
hibited to mask the detector with decorative
curtains, because at the same time, loss of its
sensitivity is possible.
Not recommended installation locations

7 INSTALLATION ORDER
1) Open cover
2) Remove PCB
3а)Wall installation
3b) Bracket
installation
Orient the base of the detector strictly
according to the figure!
4) InstallPCB and
connect wires
(see. p. 8)
5) Perform testing of Ac
and PIR channels (see.
p. 9)
8 CONNECTION
Connect to the detector terminals in accordance
with the user guide for the control panel.
RELAY –terminals for connection to the alarm
loop;
TMP –tampering terminals;
GND, +12V –power supply terminals.
9 TESTING
AC-channel:
1) Power on the detector. Indicator will blink
for 60 sec.
2) Activate AC-channel test mode. Mode
activates for 8 min.
3) Close the cover.
4) With glass break simulator (supplied
separately) check the triggering of the detector, for
acoustic noises (when hi-frequency noise –
indicator blinks
2 times per 1 sec; when low-frequency noise -
1 time per 1 sec).
PIR-channel:
PerformTEST-pass.
Moving through detection
zone with 0,3 m/sec speed
and 3 m/sec speed check
the sensitivity zones by
short enables of the
indicator.
10 WARRANTY
The operation warranty period is 5 years from the
date of operation start-up but no longer than 5
years 6 months from the date of manufacturing
subject to the requirements of the User guide.