Viavi OneAdvisor ONA-800 User manual

ONA-800 Quick Start Guide
ONA-800 Quick Start Guide 22142809 R003 1June 2020
Unpacking and inspecting the components
When unpacking the components, verify that all the items you ordered are
included in the package. Accessories might be shipped in a separate box.
Before using the unit for the first time, inspect its components to verify
that no damage occurred during shipping. Examine the connectors, ports,
LEDs, and screen for damage. Be sure to check the top, bottom, and front
panels. If you find damage, contact Viavi Customer Care at 1-844-GO-
VIAVI ([phone]) or at [email protected]. Consider saving
the box and packing materials for future use.
About the base unit
The base unit supports modules that can be added and removed as re-
quired. Powered by either external AC power or battery, the unit also fea-
tures an LCD touchscreen for quick access to the touch-based user inter-
face.
Powering the unit
The base unit with all modules installed operates from 19-27V DC and can
operate supplied by the 19V DC, 160W AC power adapter shipped with the
unit. The nominal input ratings of the power adapter are 100-240V AC, 50-
60Hz and it auto-ranges between 90-264V AC and 47-63Hz. The mains sup-
ply cord used with the power adapter shall be of grounded type with connec-
tion to protective earth.
NOTE:
The base unit has no user-serviceable internal fuse and must be
returned to VIAVI for service if needed.
Installing the battery
1Battery access door
2Field-replaceable lithium ion battery

ONA-800 Quick Start Guide
ONA-800 Quick Start Guide 22142809 R003 2June 2020
1. Place the unit so you have access to the back and remove the CAA/
OTDR modules or back cover.
2. Using the hex key located in the groove on the back panel, loosen the
four fasteners and lift the base unit off of the display panel.
3. Place the solution module into the display panel, ensuring the mating
connectors between the two pieces are aligned.
4. Insert the hex key in the brass fittings on the rear of the module and tighten
the internal captive fasteners to secure the module to the display.
5. Place the ONA-800 base onto the module, ensuring the mating connectors
are aligned.
Turning on the unit
Press the Power button for approximately 1 second, then release.
Turning off and rebooting the instrument
1. Press the Power button for approximately 1 second, then release.
2. Select the desired Power option on the display:
• Select Power off to turn your instrument off
• Select Reboot to reboot your instrument.
• Select Cancel to cancel the operation and return to the previous
screen.
When the unit is off and battery is not charging, there is no illumination of the
LED.
NOTE:
Holding the Power button for more than 7 seconds initiates a non-
graceful shutdown.
6. Using the hex key, tighten the captive fasteners on the rear of the base
that secure it to the module.
7. Re-attach the CAA/OTDR modules or back cover.
1. Power down the ONA-800 and disconnect from AC power.
2. Place the unit so that you have access to the back and remove the
back cover by removing the four screws that hold it in place.
3. Locate the hinges on the module and insert them into the base at a 45
to 60 degree angle.
4. Pivot the module down towards the connector.
5. Seat the module into the connector with slight pressure.
6. Tighten the screws on the module.
1. Power down the ONA-800 and disconnect from AC power.
2. Place the unit so that you have access to the back.
3. Remove the screws on the module.
4. Remove the module from the ONA-800.
Installing CAA/OTDR modules
Removing CAA/OTDR modules
Installing solution modules