Wine racks America Case/Base Aisle Rack User manual

Cordless Drill Utility Knife
Finish Nailer Hammer
Nail Setter
Wood Glue
*Please verify that you have the correct number of parts before proceeding.
Depending on the model you purchased, your bundle should contain the following:
Case/Base Aisle Rack
Assembly GUIDE or visit
wineracksamerica.com
Questions?
888.373.6057
Package Contents tools for assembly
Page 1
SCREWLESS BASE CONNECTOR (X1)
STANDARD CONNECTOR (X1)
SCREWLESS CONNECTOR (X3)
STANDARD BASE CONNECTOR (X1)
END LADDER
LEFT (X1)
END LADDER
RIGHT (X1)
MIDDLE LADDER
(X2)
SCREWLESS SUPPORT (X2)
STANDARD SUPPORT (X2)
MIDDLE SUPPORT (X16) INSIDE LADDER
LEFT (X1)
INSIDE LADDER
RIGHT (X1)
WOOD SCREWS
FINISH NAILS
WOOD PUTTY
End Ladder (right)
Middle Ladder
Inside Ladder (right)
Screwless Connectors
Standard
Supports
Middle Ladder
End Ladder (left)
Inside Ladder (left)
Screwless Base
Connector
Screwless
Connector
Screwless
Supports
Middle
Supports
Standard
Connector
Standard Base
Connector
Make sure notched
supports are facing
inwards

ATTACHING YOUR RACK TO THE WALL
Assembly GUIDE or visit
wineracksamerica.com
Questions?
888.373.6057
Page 2
Case/Base Aisle Rack
Depending on how many bottles you store, your wine cellar rack could weigh as much as 540 lbs.
To avoid tipping attach your racking to the wall using one of the following methods.
1. Put the rack in the desired location.
2. Shim the front of the rack so it is
parallel with the wall behind it.
3. Locate a wall stud behind the rack.
4. Drive a 2 1/2" wood screw through a
back spacer bar to attach to the stud.
1. Use "L" brackets (located at any hardware store).
2. Attach to both the rack and the wall in any out of
the way spot.
Step 1: Place parts on a flat surface. Begin by attaching the back connectors to the ladders with a cordless drill.
BACK FRONT
Step 2: Flip rack over. Use brad nailer or provided finish nails to attach front and top connectors to the ladders.
Use wood glue for added support.
Step 3: Insert middle supports into notched slots.
34 11/32"
12 25/32"
23 9/16"
Base connectors
are 2" tall
ATTACHING YOUR RACK TO THE WALL
Measurements are from
the bottom of the rack to
the top of the connector
IMPORTANT!