Wine racks America Point of Purchase User manual

Cordless Drill Utility Knife
Finish Nailer
Hammer Nail Setter
Wood Glue
*Please verify that you have the correct number of parts before proceeding.
Depending on the model you purchased, your bundle should contain the following:
Point of Purchase
Assembly GUIDE or visit
wineracksamerica.com
Questions?
888.373.6057
Package Contents tools for assembly
Page 1
INSIDE BASE
SUPPORT (X2)
WOOD SCREWS
FINISH NAILS
WOOD PUTTY
OUTSIDE BASE
SUPPORT (X2)
FRONT/BACK
BASE SUPPORT (X2)
SIGN HOLDER (X1)
BOTTLE
HOLDER (X6)
SHORT RISER
LEFT (X1)
SHORT RISER
RIGHT (X1)
STANDARD
RISER (X2)
Inside Base Support
Standard Riser
Short Riser (right)
Standard Riser
Short Riser (left)
Front/Back Base Support
Sign Holder
Outside Base Support

Assembly GUIDE or visit
wineracksamerica.com
Questions?
888.373.6057
Page 2
Point of Purchase
Step 1: Place parts on a flat surface. Use a brad nailer or provided finish nails
to attach front/back base supports to the outside base supports. Use
wood glue for added support. Figure A.
Step 2: Attach right and left side risers to the inside base supports using
cordless drill or screwdriver.
Step 3: Attach risers and inside base supports to the outside base supports
using cordless drill or screwdriver.
Step 1
Step 2
Step 3
Step 4: Attach bottle holders to the risers using a cordless drill or screwdriver.
Start screws through risers and use them to align to the pre-drilled
holes on the bottle holders. Repeat for all rows.
Step 5: Attach sign holder to the risers using a cordless drill or screwdriver.
Step 4
Step 5