Wine racks America Decorative Cellar Arch User manual

*Please verify that you have the correct number of parts before proceeding.
Depending on the model you purchased, your bundle should contain the following:
Decorative Cellar Arch
Assembly GUIDE or visit
wineracksamerica.com
Questions?
888.373.6057
Package Contents tools for assembly
Page 1
Cordless Drill Finish Nailer
Hammer Nail Setter
+
Screwdriver
Required
Wood Glue
Suggested
RIGHT SIDE PIECE (x1)
LEFT SIDE PIECE (x1)
ARCH PIECE (x1)
TRIM PIECE (x1)
LIGHT BAR/PUCK LIGHT (x1)
WOOD SCREWS FINISH NAILS
WOOD PUTTY
Trim Piece
Arch Piece
Side Piece (right)
Light Bar
Side Piece (left)

Assembly GUIDE or visit
wineracksamerica.com
Questions?
888.373.6057
Page 2
Decorative Cellar Arch
1. Place parts on a flat surface. Begin by attaching the (right) side piece to the arch piece with a screwdriver or
cordless drill. Make sure the top of the side piece is aligned with the top of the arch piece. Repeat for (left) side.
(figure 1)
2. Attach the top trim piece so that the top edge of the trim piece fits flush with the top edge of the arch and side
assemblies. Make sure that the unit is flat on the floor or a table while attaching the top trim piece. (figure 2)
Secure the top trim piece using a finish nailer. Simply drive 2 finish nails (one at each end) through the top trim
piece securing it to each side assembly. (figure 3)
If you do not have a finish nailer, drive one of the provided finish nails through each end of the top trim piece
into the side assemblies until it is flush. Then, countersink the nail using a nail setter until the head of the nail is
about 1/16" below the surface of the wood.
3. Fill the nail holes using the wood putty provided. Simply push the putty into each hole using your thumb and
wipe excess putty off the surface using a damp cloth.
1
ATTACH SIDE
PIECES TO ARCH
3
SECURE WITH
FINISH NAILS
or
finish nail
(included)
2
ATTACH TRIM
PIECE

Assembly GUIDE or visit
wineracksamerica.com
Questions?
888.373.6057
Page 3
Decorative Cellar Arch
4. The Wine Racks America Cellar Arch comes pre-configured with an attached puck light. Simply set it down into
place through the top of the arch.
Guide the power cord through one of the two holes on the back of the arch. The hole closest to the nearest outlet
is best. Plug in the power cord to make sure the light works correctly.
5. Stand up your arch and lift it into place. The Wine Racks America Cellar Arch is designed to be installed above one
of our base racks with a solid top.
WINERACKSAMERICA.COM
360 North 700 West Suite F • North Salt Lake, UT 84054
(toll free) 888-373-6057
(fax) 801-936-0534
Once again, thank you for your business. Remember, customer
service is available to answer any questions Monday-Friday
7:00 am - 5:00 pm MST. Please feel free to contact us for any
wine storage needs.
We would love to see your wine racks in use! Please feel free to
send any photos of your racks to [email protected]