Wine racks America Magnum Aisle Rack User manual

Cordless Drill Utility Knife
Finish Nailer Hammer
Nail Setter
Wood Glue
*Please verify that you have the correct number of parts before proceeding.
Depending on the model you purchased, your bundle should contain the following:
Magnum Aisle Rack
Assembly GUIDE or visit
wineracksamerica.com
Questions?
888.373.6057
Package Contents tools for assembly
Page 1
SCREWLESS BASE CONNECTOR (X1)
STANDARD CONNECTOR (X1)
SCREWLESS CONNECTOR (X2)
STANDARD BASE CONNECTOR (X1)
END LADDER
LEFT (X1)
END LADDER
RIGHT (X1)
MIDDLE LADDER
(X8)
End Ladder (right)
Middle Ladder
Screwless Connector
Screwless Base Connector
Standard Base
Connector
Standard Connector
End Ladder (left)
Base Connectors are
2” in height.
WOOD SCREWS
FINISH NAILS
WOOD PUTTY
IMPORTANT!
Make sure the slanted
bottle supports are
facing the front of the rack

ATTACHING YOUR RACK TO THE WALL
Assembly GUIDE or visit
wineracksamerica.com
Questions?
888.373.6057
Page 2
Depending on how many bottles you store, your wine cellar rack could weigh as much as 540 lbs.
To avoid tipping attach your racking to the wall using one of the following methods.
1. Put the rack in the desired location.
2. Shim the front of the rack so it is
parallel with the wall behind it.
3. Locate a wall stud behind the rack.
4. Drive a 2 1/2" wood screw through a
back spacer bar to attach to the stud.
1. Use "L" brackets (located at any hardware store).
2. Attach to both the rack and the wall in any out of
the way spot.
BACK FRONT
Measurements are from
the bottom of the rack to
the top of the connector
IMPORTANT!
23 9/16"
Base connectors
are 2" tall
ATTACHING YOUR RACK TO THE WALL
Step 1: Place parts on a flat surface. Make sure the slanted bottle supports are all facing towards the front of the rack.
Begin by attaching the back connectors to the ladders with a cordless drill.
Step 2: Flip rack over. Use brad nailer or provided finish nails to attach front and top connectors to the ladders.
Use wood glue for added support.
Magnum Aisle Rack