Wine racks America Split Wine Cellar Kits User manual

Split wine cellar kits
Assembly GUIDE
Cordless Drill Utility Knife
Finish Nailer
Hammer Nail Setter
Wood Glue
*Please verify that you have the correct number of parts before proceeding.
Depending on the model you purchased, your bundle should contain the following:
Package Contents tools for assembly
Page 1
or visit
wineracksamerica.com
Questions?
888.373.6057
END STANDARD SCREWLESS 1" FINISH
LADDERS SPACER BARS SPACER BARS SCREWS NAILS
2 6 2 12 4
*Fill the nail holes using the wood putty provided. Simply push the putty into each hole using
your thumb and wipe excess putty off the surface using a damp cloth.
Align to the top of 13 bottle
support from the bottom
Align to the top of 7 bottle
support from the bottom
Connector Alignment
End Ladder
Standard Spacer Bar
Screwless Spacer Bar
Standard Spacer Bar

The top of the spacer
bars align with the top
of the bottle supports
ATTACHING YOUR RACK TO THE WALL
Split wine cellar kits
Assembly GUIDE or visit
wineracksamerica.com
Questions?
888.373.6057
26 5/8" From
the bottom
51 3/4" From
the bottom
Page 2
* Minimize the risk of splitting your ladders by drilling a 1/16" pilot hole before driving the wood screws.
For best results, drive the screw most of the way in with your drill, then finish tightening by hand.
Depending on how many bottles you store, your wine cellar rack could weigh as much as 540 lbs.
To avoid tipping attach your racking to the wall using one of the following methods.
1. Put the rack in the desired location.
2. Shim the front of the rack so it is
parallel with the wall behind it.
3. Locate a wall stud behind the rack.
4. Drive a 2 1/2" wood screw through a
back spacer bar to attach to the stud.
1. Use "L" brackets (located at any hardware store).
2. Attach to both the rack and the wall in any out of
the way spot.