Yealink T48G User manual

Yealink T48G Setup Guide
To configure the Yealink T48G to your MaxoTel account, first retrieve the IP Address so that you can log
into the ‘Web Configuration’ via your computer. To do this, the ‘OK’ button in the middle of the D-Pad.
The IP Address should show up in the Status Page. Enter The IP Address into your web browser.
Once you are on the Web Configuration page enter the username and password. By default the
username will be ‘admin’ and the Password will be ‘admin’.
Once you have successfully logged in, click on the ‘Account’ tab across the top. Here you will place your
Extension information and the SIP Server (sip.maxo.com.au for Residential and Sip Trunk accounts, and
pbx.maxo.com.au for Hosted PBX accounts) as the bellow screenshot shows:
Hit the ‘Confirm’ Button at the bottom of the page to save the details. Once the page has reloaded, click
on advanced and type ‘50002’ into the ‘Voicemail’ field. This is the voicemail number. Again hit ‘Confirm’
to save the settings.

Next, click on the ‘DSSKey’ tab at the top. In here you will configure the multiple lines for the once
extension, allowing you to make and receive multiple calls through your extension number.
Feel free to also setup some Speed Dials for important numbers. If you would like to setup BLF (Busy
Lamp Field) to see the status of the other extensions please refer to the BLF Guide for this phone model
on the MaxoTel website.
Now that the lines have been configured, you will now want to set the time zone and time format,
which can be done under the top ‘Settings’ tab, and then the ‘Time and Date’ button on the left.
At this point, the phone should be ready to go. If you have any troubles making and receiving calls from
here on in, please give MaxoTel a call on 1800121210.