ZKTeco IN710 User manual

Quick Start Guide
IN710
Version: 1.2
Due to regular upgrades of systems and products, ZKTeco could not guarantee exact consistency between the
actual product and the written information in this manual.

1
Overview
167.00mm
23.50mm
135.00mm
Front Rear
Side
Top
Bottom
Microphone
Card Reading Area
Fingerprint Sensor
Speaker
5-inch HD Touchscreen
Reset
Indicator

Interface Description
Network Interface
Type-C
12V Power In
Access Control
Finger Placement
Recommended fingers: Index, middle, or ring fingers.
Avoid using the thumb or pinky finger, as they are difficult to press accurately on the
fingerprint reader.
2

Installation Environment
Please refer to the following recommendations for installation:
Device Installation
3
The IN710 requires no difficult installation, just fix the device on a flat table.

4
Power Connection
Recommended AC Adapter:
1) Rating of 12V and 3A.
2) To share the device's power with other devices, use a power supply with higher
current ratings.
Ethernet Connection
After the device is powered on, connect the network connector via the Ethernet
cable.
AC Adapter
DC V, 3A

Connect the device and computer via a Type-C cable.
5
Type-C Connection
Door Sensor, Exit Button and Lock Relay Connection
Door Sensor and Exit Button:

The system supports Normally Opened Lock and Normally Closed Lock. The NO
LOCK (normally unlocked when power-ON) is connected to 'NO' and 'COM'
terminals, and the NC LOCK (normally locked when power-ON) is connected to 'NC'
and 'COM' terminals. For an example, refer to the below-mentioned NC Lock:
1)Device not sharing power with the lock 2)Device sharing power with the lock
6
Lock Relay Connection:
GND
+5V +5V

New User Registration
7
Click on icon> [User Mgt.] > [New User] to register a new user. The options in-
clude entering the user ID and Name, setting User Role and Verification Mode,
registering ID Card, Fingerprint and Password.
L
LL
When there is no super administrator set in the device, click on to enter the menu.
Add a new user and set User Role to Super Admin, then the system requests for the
administrator’s verification before entering the menu. It is recommended to register a
super administrator initially for security purposes.

Ethernet
Click on icon > [COMM.] > [Ethernet] to set the network parameters. If the TCP/IP
communication of the device is successful, the icon will be displayed in the
upper right corner of the standby interface.
8
LL
Access Control
Click on to enter the access control interface and set relevant icon > [Access Control]
parameters of access control.
L

Attendance Record
Click on icon > [ Search] Record to enter the Attendance > [Attendance ]
personal record search, input the user ID and select the time range. Then the
corresponding attendance record will be displayed.
9
System
Click on icon > [System] to enter the system interface to set the related system
parameters for optimizing the accessibility of the device.
L
L