Allsteel Approach User manual

Pour des instructions en francias, appelar le 800-822-7653
Para instrucciones en enspanol, llame al 800-822-7653 3430400200 A
Allsteel Inc.
Muscatine, Iowa 52761-0071
Approach Table Desk
Installation Instructions

1. Protect worksurface by clearing the build area of any debris that can cause damage.
2. Place worksurface upside down (as shown) on carpet, cardboard or equivalent to
protect upward facing show surface during the installation process.
3. Open hardware pack and lay out the contents.
Build table with
underside facing up
Protect this surface and
edges of the top
1. Align leg with pre-drilled holes.
2. Use Truss head screws provided in hardware pack to assemble legs to worksurface.
*Only 4 of 8 holes will be used per leg
Hardware - Total Quantities Shown:
Build staging – Step 1
Step 2
Approach Table Desk Installation Packet
Failure to install product as instructed, use of hardware other than that which is provided, or failure to comply
X 16 X 1
1/4-20 x 3/4” Truss Head Screw Phillips Screwdriver
with instructions can result in product failure, personal injury, or property damage.
WARN I N G
3430400200 A
(08/2020)
Pages 2 of 3
X 4 per leg

Step 3 - Flip table
Use the pre-installed leveler for micro-adjustments only.
The leveler is not intended to be used as main method
of levelling.
Leg Adjustment w/ Allen Key
1.
2.
Loosen bolt (screwdriver) and set screw (1/8" Allen key) to allow for
leveling.
While lifting slightly on the worksurface, slide the leg up or down to level as
needed.
Tighten both the bolt and the set screw. Ensure the set screw is tightened
until flush with the outer surface of the shroud.
Note:
Approach Table Desk Installation Packet
3430400200 A
(08/2020)
Page 3 of 3
micro-adjustments only.
Leg Adjustment:
1/8" ALLEN KEY (used for minor adjustment – not provided)
Set Screw
flush with surface
when tight
3.
Bolt