Allsteel Mind-Share Service manual

343-2896A
Page 1 of 2 (06/13)
Mind-Share with screen Installation Packet
Illustration 1. Identify the front of the screen
Step 1: Locate hole cutouts on the screen.
Step 2: Lay screen down on the oor as shown. Align holes in seat to match the
desired hole position on the screen. Assemble the seat to the screen through the
bottom of the seat.
Illustration 2. Assemble seat to screen
BackFront
Assemble through
seat opening Overhang to right
Centered
Overhang to left
Seat
Screen

343-2896A
Page 2 of 2 (06/13)
Mind-Share with screen Installation Packet
Illustration 3. Assemble counterweights
Step 3: Oriented as shown, slide rods into holes in
vertical members.
Step 4: Slide in counterweights and secure with two
washers and two nuts.
Illustration 4. Repositioning unit
Note: All seats will use a 20 lb counterweight.
Step 5: Flip the unit back to the upright position as shown.
Final position Initial position
Hole
Rod
Counterweight
Rod
Washer
Washer
Nut