B. Braun Aesculap AdTec monopolar User manual

DISASSEMBLY
Deactivate ratchet on ratchet handle
Flip down red toggle switch.
N.B.: for PO959R only
IDisconnect shaft and handle
Pull rotation knob back until it locks in place. A red
ring becomes visible.
Important: Do not hold on to the movable handle component.
II Assemble shaft II
Slide the outer insulation tube as far as it will go
over the inner metal tube.
II
Remove shaft from handle
Remove the shaft by pulling the
instrument shaft out of the handle. III
Disassemble shaft I
Hold the jaw insert at the tip and remove the outer
insulation tube.
I V
Prepare handle
If the red ring is not visible, pull the rotation knob
back. Deactivate the ratchet by flipping down the
red toggle switch.
N.B.: for PO959R only
Connect shaft and handle
Hold the shaft firmly by its tip and the handle behind
the rotation knob. Push the shaft into the handle until
it locks in place and the red ring disappears.
Important: Do not hold on to the movable handle component.
Disassemble shaft II
Hold the jaw insert at the tip and remove
the inner metal tube.
V
ASSEMBLY
CARE REPAIRS
Reprocess the product immediately after use
The product can be sterilized either in disassembled or in assembled condition
For advice on cleaning, disinfection and sterilization, please follow the instructions for use
For the latest information on reprocessing, please also refer to the Aesculap Extranet via www.aesculap-extra.net
For accessories and spare parts, please refer to Brochure C766 or visit www.endoscopy-catalog.com
PROCESSING & ACCESSORIES
Lubricate the defined places on the
instruments (instruments jaw and
red toggle switch) with Aesculap
Sterilit Oil after each cleaning cycle.
Aesculap Endoscopic Technology
V
Function test
Test the assembly of the instrument by opening and
closing the handle to ensure the jaw is opening and
closing.
In order to ensure the preservation of full guarantee and
warranty rights, only persons authorized by Aesculap may
carry out repairs.
Please send products for repair to: Aesculap Technical Service,
Am Aesculap-Platz, 78532 Tuttlingen, Germany.
Additional service addresses may be obtained from the same
address or via [email protected]
IAssemble shaft I
Slide the metal inner tube onto the jaw insert
with its four spring tongues towards the working
end until the tongues snap in place.
jaw insert
inner metal tube
outer insulation tube
I V
toggle switch
rotation knob
movable handle component



III

Aesculap Endoscopic Technology
AdTec®monopolar
Disassembly and assembly instructions
Brochure No. C 222 02
All rights reserved. Technical alterations are possible. This leaflet may be
used for no other purposes than offering, buying and selling of our products.
No part may be copied or reproduced in any form. In the case of misuse we
retain the rights to recall our catalogues and pricelists and to take legal actions.
Aesculap AG & Co. KG
Am Aesculap-Platz
78532 Tuttlingen
Germany
Phone [phone]
Fax [phone]
www.aesculap.de
0906/1.0/1