Balanced Body CoreAlign User manual

Contact Us
1-800-PILATES | [phone]
pilates.com | [e-mail]
400-196 | 07.05.18
How to Assemble the Balanced Body®
CoreAlign®Brackets for Wall Tower Mount
LADDER SOLD SEPARATELY. LADDER ASSEMBLY MUST
BE COMPLETE BEFORE BEGINNING.
PARTS LIST
Complete ladder (sold separately) 731-001 or 731-004
PARTS
Ladder Adapter (3) 707-237
Wall Mounting Ladder Bracket
(2/4 not needed with newer ladders.
See note below.) (2) 616-085
12 x 3/4¾ Screw (6) GEN9033
10 x 1 Screw (Not needed with newer ladders.
See note below.) (4) GEN9034
TOOLS YOU WILL NEED (NOT INCLUDED):
»Large head Phillips screwdriver (# 3 tip)
Assembled ladder is 91” (231 cm) tall. Contact
Balanced Body if your ceiling is lower than
91”.
TO S TART:
Step 1: Your ladder assembly should be
complete. Fig 1. Note: Center brackets may
be required with older ladders that were
shipped with 4 brackets; these are included.
See ladder assembly instructions or contact
Balanced Body.
Fig 1
STEP 2
Using 12 x 3/4¾
screws, attach the
ladder adapter to
the brackets of the
ladder. Note: Holes
are pre-drilled. Fig 2
STEP 3
Repeat on the other two adapters. Fig 3
STEP 4
Rotate the clamps
upward and place
the ladder against
the Wall unit.
Rotate the clamps
back downwards to
attach. Repeat on
all brackets. Fig 4
Fig 2
Adapter bracket
Screws
Fig 3
Fig 4
Clamp

Contact Us
1-800-PILATES | [phone]
pilates.com | [e-mail]
400-196 | 07.05.18
STEP 5
Secure the ladder by tightening knobs.
Repeat on all knobs for each bracket. Fig 5
When complete, the ladder for Wall Tower will
look like Fig 6 (reverse view).
Fig 5
Clamp Knot
Fig 6
VERTICAL STORAGE OPTION USING THE HANDLES
AND STRAPS
To store your CoreAlign vertically, move the
carts to the end nearest the ladder and
attach all resistance bands. Move the unit
about 8-10” away from the ladder. On each
side of the ladder, place the loop-end of the
ropes on the long dowel, second from the
bottom. Tip the unit until it is on its end. Note:
A mat may be used underneath to prevent
any scratches to the floor. Diagonally wrap
each rope around the unit and secure the
handle on the top long dowel. See Figure 7.
QUESTIONS?
Please call Balanced Body Technical Support
at 1-800-PILATES (U.S.) or [phone]
Fig 7