Ballard Designs Eastman MO196 User manual

Prevent accidentally discarding small parts or
hardware. Retain all carton contents until assembly
and installation are complete.
PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 1/12/2021 Page 1 of 4
PRODUCT NAME: Eastman Secretary
ITEM NUMBER: MO196
ASSEMBLED DIMENSIONS : 52”H x 32”W x 17 1/4”D
IMPORTED
Customer Service: 800-367-2810
Online: www.ballarddesigns.com

Page 2 of 4
Ltr.
A 4
B2
Qty. Hardware Included
Ltr. Qty. Components
C1
REQUIRED TOOLS:
Phillips Screwdriver
-Two person assembly suggested.
Remove all parts, hardware and
protective packaging from carton
and carefully arrange on a clean,
level, padded surface.
File Rods
Wall Anchoring
(Anti-Tip) Kits
See Page 4
Secretary (C)
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
ANCHORING HARDWARE INCLUDED
Cleaning and Care
Periodically dust with a soft, dry cloth.
Prevent finish damage: do not use alchohol based
cleaners or polishers. Promptly remove spills.
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Assemble in location for intended use.

Page 3 of 4
STEP 1: Open Lower Drawer and place File Rods (A) into notches along inside upper edge.
NOTE: Drawer does not need to be completely removed to install Rods.
(A)
LEVELERS: Secretary is equipped with Rotary Levelers under each corner. If necessary, Secretary
may be adjusted by carefully lifting applicable corner and turning Leveler clockwise/counterclockwise.
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
NOTE: Drawer does not need to be completely removed to install rods.
Assemble in location for intended use.

Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
ANCHORING HARDWARE INCLUDED
Page 4 of 4
Installation:
Ltr.
A2
Small Screw
Retention Belt
Qty. Hardware Included
B2
Large Screw
C4 Bracket
D2
WALL ANCHORING HARDWARE (ANTI-TIP)
1. Place furniture against wall at desired location then locate and mark a Wall Stud behind unit.
2. Corresponding to Stud location, attach one Bracket (C) to back of unit using Small Screw (B).
3. To keep hardware out of view after installation, attach remaining Bracket (C) INTO WALL STUD
with Large Screw (A) 2 inches below Bracket attached to back of unit.
4. Move unit into place, align Brackets then connect both using Retention Belt (D).
5. Confirm Belt is securely laced and locked.
W
A
L
L
S
TUD
WALL BRACKET MUST BE ATTACHED TO WALL STUD
(A)
(B)
(C)
(D)
R
e
presen
t
a
tiv
e
Fu
r
nitu
r
e
I
tem
Customer Service: 800-367-2810
Online: www.ballarddesigns.com