Ballard Designs SUZANNE KASLER MO585 4DR User manual

PRODUCT NAME: SK Geneva Faceted 4 Drawer *Cabinet
ITEM NUMBER: MO585 4DR
ASSEMBLED DIMENSIONS: 25 3/4”H x 17 1/4”W x 22 3/4”D
PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 7-9-2020 Page 1 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
MADE IN CHINA
SUZANNE KASLER
BALLARD DESIGNS
*Cabinet designed to fit under SK Geneva Faceted Desk (Sold Separately)

Customer Service: 800-367-2810
Online: www.ballarddesigns.com Page 2 of 4
Assemble in location for intended use.
Cleaning and Care
Periodically dust with a soft, dry cloth.
Prevent finish damage: do not use alchohol based
cleaners or polishers. Promply remove spills.
Prevent accidentally discarding small parts or
hardware. Retain all carton contents until assembly
and installation are complete.
REQUIRED TOOLS:
Phillips Screwdriver
Two person assembly suggested.
Remove all parts, hardware and
protective packaging from carton and
arrange on a clean, level surface.
Ltr.
Qty.
Hardware Included
Components
Ltr.
Qty.
Hardware
Packet
WARNING
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
ANCHORING HARDWARE INCLUDED
Wall Anchoring
(Anti-tip) Hardware Kit
(see page 4)
Cabinet (B)

Page 3 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
STEP 1: Cabinet is equipped with Rotary Levelers under each corner. If necessary, Cabinet may be
adjusted by carefully tipping applicable corner and turning Leveler clockwise/counterclockwise.
STEP 2: Slide Cabinet (B) under SK Geneva Faceted Desk (Ballard Designs Item Number MO584).
Desk sold separately.
Desk Sold Separately
(B)
Assemble in location for intended use.

Page 4 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Installation:
Ltr.
A1
Small Screw
Retention Belt
Qty. Hardware Included
B1
Large Screw
C2 Bracket
D1
WALL ANCHORING HARDWARE (ANTI-TIP)
1. Place furniture against wall at desired location then locate and mark a Wall Stud behind unit.
2. Corresponding to Stud location, attach one Bracket (C) to back of unit using Small Screw (B).
3. To keep hardware out of view after installation, attach remaining Bracket (C) INTO WALL STUD
with Large Screw (A) 2 inches below Bracket attached to back of unit.
4. Move unit into place, align Brackets then connect both using Retention Belt (D).
5. Confirm Belt is securely laced and locked.
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
W
A
L
L
S
TUD
WALL BRACKET MUST BE ATTACHED TO WALL STUD
(A)
(B)
(C)
(D)
R
e
presen
t
a
tiv
e
Fu
r
nitu
r
e
I
tem