Ballard Designs CASA Florentina TD330 User manual

PRODUCT NAME: Sorrento Dining Table
ITEM NUMBER: TD330
DIMENSIONS OF ITEM ASSEMBLED:
31”H x 84”W x 41”D
This item is not intended for commercial use.
Made in Italy.
Page 1 of 3
2010 Ballard Designs, Inc.
Check to ensure that you have the following:
Hardware Included
.ytQ.rtL
A 8
B 8
Part List
.ytQ.rtL
D 1
Top
E 4
Legs
F 2
Leaves
C 1
Nuts
Washers
Tool
800.367.2810
www.ballarddesigns.com
For Assembly Purposes:
-Requires 2 people.
- Leaf storage underneath
the table.

800.367.2810
www.ballarddesigns.com
STEP 1: Leg Installation
Page 2 of 3
2010 Ballard Designs, Inc.
Lay Table Top (D) upsidedown.
DO NOT remove any of the protective wrapping before.
Then attach Legs (E) to the Table Top (D) with 2 Nuts (A) and Washers (B) for each leg.
Use the given Tool (C) to tighten the Bolts. For additional torque, place a
screwdriver thought the top holes of the Tool (C) and then tighten.
Flip Table upright and remove plastic wrapping.
Be careful of the legs when flipping the table upright.
(E)
(E)(E)
(D)
(C)
(B)
(A)

STEP 2: Leaf Installation
Cleaning & Care:
DO NOT use alcohol based products or spray polisher as they can damage the finish.
Dust with soft cloth. One to two times monthly apply beeswax polish as needed.
Finish can be affected by heat or extended contact with oils or wine.
Page 3 of 3
2010 Ballard Designs, Inc.
800.367.2810
www.ballarddesigns.com
Unlock the Table Top (D) and pull it apart. The locks are underneath the Table Top.
Then Lay the Leaf (F) on the rails, being sure to align the pegs on the bottom
of the leaf with the holes in the rails.
Slide the Table Top (D) back together and lock the leaf in.
(UNLOCK)
(F)
(F)
(D)
(D)