Ballard Designs Tuscan MA166 User manual

PRODUCT NAME: Tuscan Media Console
ITEM NUMBER: MA166
ASSEMBLED DIMENSIONS: 34”H x 52 1/2”W X 20”D
PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 6-13-2019 Page 1 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
IMPORTED

Customer Service: 800-367-2810
Online: www.ballarddesigns.com Page 2 of 4
TOOLS NEEDED:
-Assembly may require 2 people.
-May require a Flathead screwdriver.
-Requires a Phillips head screwdriver.
Ltr.
A 16
Wood Plugs
B 4
Shelf Supports
Console (D)
Shelves (E)
C 2
Qty. Hardware Included
Ltr.
D
E
1
4
Qty. Components
Anti Tip Kits
NOTE: To avoid accidentally
discarding small parts or hardware,
retail all carton contents until
assembly and installation
are complete.
Hardware located here (A-C)
Shelves (E)

Page 3 of 4
STEP 1: Insert Shelf Supports (A) into desired locations inside Console (D). Gently place
Shelves (E) onto Shelf Supports.
If necessary, Console may be leveled by adjusting the interior Rotary Levelers located on
bottom of each corner. To access, open doors and using a Flathead Screwdriver, turn
clockwise or counterclockwise until the Console is level. Afterward, insert a Wood Plug (B)
into each opening to hide holes.
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
STEP 2:
(A)
(E)
(D)
(B)

Page 4 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Ltr.
F
(F)
(G)
(H) (H)
(I)
2 Small Screws
Retention Belts
Qty. Hardware Included
ANTI TIP INSTALLATION: PART C
G2 Large Screws
H4 Brackets
I2
Cleaning & Care:
DO NOT use alcohol based products or spray polisher as they can damage the finish.
Dust with soft cloth. One to two times monthly, apply beeswax polish as needed.
Finish can be affected by heat or extended contact with oils or wine.
(D)
(F)
(G)
(H) (H)
(I)
WALL
STUD
WARNING
Tip-Over Hazard
WALL BRACKET MUST BE ATTACHED TO WALL STUD
Prevent tipping accidents. Anchor your furniture.
Attach 2 Brackets (C) to back of Console with Small Screws (A) placed through smaller hole.
Attach remaining Brackets (C) INTO A WALL STUD with Large Screws (B) 2 inches below
the Brackets attached to Console. Align the Brackets vertically and string in the Retention Belts (D).
Confirm Straps are securely laced and locked.