Ballard Designs Hazel UD217 User manual

Uncrating and Assembly Instructions
PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 8-6-2020 Page 1 of 3
PRODUCT NAME: Hazel Dining Chair
ITEM NUMBER: UD217
ASSEMBLED DIMENSIONS : 32”H x 24.5”W x 22”D
MADE IN CHINA
Customer Service: 800-367-2810
Online: www.ballarddesigns.com

Page 2 of 3
Ltr.
A 1
Qty. Hardware Included
REQUIRED TOOLS:
Allen Wrench (included)
-Two person assembly suggested.
Allen Wrench
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
STEP 1: Stand Chair upright as illustrated below and remove all four Bolts from Top using Allen Wrench.
Carefully remove Top and set aside.
(A)
STEP 2: Set Chair onto its side as illustrated below, remove all four Bolts from bottom corners then set
Support posts aside.
(A)
Support Posts

Page 3 of 3
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
STEP 3: With Chair still on its side, use fingers to carefully remove all four Levelers from bottom of
Chair legs. Remove shipping panel and set aside. Replace Levelers onto each leg.
LEVELERS
Remove and Replace
N
O
T
E
After installation, Chair level may be adjusted by turning Levelers clockwise/counterclockwise.