Ballard Designs Chilton MI387 User manual

PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 2-26-2020 Page 1 of 4
PRODUCT NAME: Chilton Curved Corner Cabinet
ITEM NUMBER: MI387
ASSEMBLED DIMENSIONS : 74 13/32”H x 27 3/4”W x 18 3/4”D
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
MADE IN CHINA

Customer Service: 800-367-2810
Online: www.ballarddesigns.com Page 2 of 4
Ltr.
A 1
B4
Qty. Hardware Included
Ltr.
E
1
1
Qty. Components
D
TOOLS NEEDED:
Phillips Screwdriver
-Two person assembly suggested.
Remove all parts, hardware and
protective packaging from carton
and carefully arrange on a clean,
level, padded surface.
NOTE: To avoid accidentally
discarding small parts or hardware,
retain all carton contents until
assembly and installation are complete.
Back Shelf Support
Wall Anchoring
(Anti-Tip) Hardware
Kit
See page 4
Shelf (D)
Cabinet (E)
Assemble in location for intended use.
WARNING
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
ANCHORING HARDWARE INCLUDED
Shelf
Hardware Packet
C2
Side Shelf Supports

Page 3 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
(D)
INSTALL SHELF: Determine location for Shelf (D) then insert Back Shelf Support (A) into pre-drilled
hole in back corner. Insert SIde Shelf Supports (B) into pre-drilled holes on both sides.
(A)
(B)

Installation:
Page 4 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Cleaning & Care:
DO NOT use alcohol based products or spray polisher as
they can damage the finish. Dust with soft cloth.
(B)
(A)
(C)
(C)
(D)
Ltr.
A2
Small Screw
Retention Belt
Qty. Hardware Included
B2
Large Screw
C4 Bracket
D2
ANCHORING HARDWARE (ANTI-TIP)
1. Locate and mark a Wall Stud behind unit at location for installation.
2. Corresponding to Stud location, attach one Bracket (C) to back of unit using Small Screw (B).
3. To keep hardware out of view after installation, attach remaining Bracket (C) INTO WALL STUD
with Large Screw (A) 2 inches below Bracket attached to back of unit.
4. Move unit into place, align Brackets then connect both using Retention Belt (D).
5. Confirm Belt is securely laced and locked.
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
WALL BRACKET MUST BE ATTACHED TO WALL STUD
WALL
STUD
BACK OF FURNITURE ITEM