Ballard Designs Cossette MQ116 User manual

PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 2-8-2021 Page 1 of 3
PRODUCT NAME: Cossette Console
ITEM NUMBER: MQ116
ASSEMBLED DIMENSIONS : 28 1/4"H X 74 3/4"W X 20"D
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
MADE IN INDIA

Customer Service: 800-367-2810
Online: www.ballarddesigns.com Page 2 of 3
Ltr.
A 2
Qty. Hardware Included
Ltr.
C
D
1
1
Qty. Components
B 2
REQUIRED TOOLS:
Phillips Screwdriver
-Two person assembly suggested.
Remove all parts, hardware and
protective packaging from carton
and carefully arrange on a clean,
level, padded surface.
NOTE: To avoid accidentally
discarding small parts or hardware,
retain all carton contents until
assembly and installation are complete.
Wall Anchoring
(Anti-tip) Kits
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
ANCHORING HARDWARE INCLUDED
Center Shelves (B)
Console (E)
Assemble in location for intended use.
Left Shelf (C)
Right Shelf (D)
E1
(C)
SHELVES: Gently insert and lay Left Shelf (C) onto pre-installed Brackets inside Console (E). Repeat
process for Right Shelf (D) and both Center Shelves (B). See illustration below.
(B) (B)
(D)
Cleaning and Care
Periodically dust with a soft, dry cloth.
Protect surfaces to prevent damage.
Do not use alchohol based cleaners or polishers.

Page 3 of 3
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Cleaning & Care:
DO NOT use alcohol based products or spray polisher as
they can damage the finish. Dust with soft cloth.
Ltr.
A 4
Qty. Hardware Included
WALL ANCHORING (ANTI-TIP) HARDWARE INSTALLATION
B
C
4
2
Screws
D-Ring Brackets
Retention Belts
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
1. Place furniture against wall at desired location then locate and mark a Wall Stud behind unit.
2. Corresponding to Stud location, attach one Bracket (B) to back of unit using Screw (A).
3. To keep hardware out of view after installation, attach remaining Bracket (B) INTO WALL STUD
with Screw (A) 2 inches below Bracket attached to back of unit.
4. Move unit into place, align Brackets then connect both using Retention Belt (C).
5. Confirm Belt is securely laced and locked.
(A)
(B)
(C)
W
ALL
S
T
U
D
WALL BRACKET MUST BE ATTACHED TO WALL STUD
x2
x2
R
ep
re
s
en
t
a
t
i
v
e
Furnit
u
re
I
t
e
m
(A)