Ballard Designs WS994 User manual

PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 1-19-2022 Page 1 of 4
PRODUCT NAME: Jewelry Mirror
ITEM NUMBER: WS994
ASSEMBLED DIMENSIONS : 60”H x 24”W x 5”D
MADE IN CHINA
Customer Service: 800-367-2810
Online: www.ballarddesigns.com

Page 2 of 4
Ltr.
A 2
B 2
Qty. Hardware Included
Ltr.
D
E
1
1
Qty. Components
C 2
REQUIRED TOOLS:
Phillips Screwdriver, Level, Pencil,
Drill with 1/4” Bit, Small Hammer
-Two person assembly suggested.
Remove all parts, hardware and
protective packaging from carton
and carefully arrange on a clean,
level, padded surface.
Wall Anchors
Wood Screws
(For use when Wall Stud is
present or with Wall Anchor)
Expansion Bolts
For use in open drywall.
(No Wall Stud present)
Prevent accidentally discarding small
parts or hardware.
Retain all carton contents until
assembly and installation are complete.
Jewelry Mirror (D)
Wooden Cleat (E)
NOTE: Cleat ships inside
channel on back of cabinet.
Remove from cabinet to
install.
For use in open drywall.
(No Wall Stud present)
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Loaded Jewelry Mirror will be heavy.
At least one screw securing Cleat (E) should be anchored into a wall stud.
NOTICE
Assemble in location for intended use.

Customer Service: 800-367-2810
Online: www.ballarddesigns.com Page 3 of 4
STEP 1: Determine location for Jewelry Mirror (D), locate Wall Stud(s) inside wall. Use a Level and
Pencil to position then mark wall for Cleat.
Best support provided by driving Wood Screw (A) directly into a Wall Stud.
Expansion Bolts (B) provide best support where not Wall Stud is present.
Wall Anchors (C) are used when one Screw in Cleat is anchored to a Wall Stud or an Expansion
Bolt.
DO NOT USE WALL ANCHORS ALONE as they may pull out of wall once cabinet is loaded.
Wall
Wall Stud
(A)
(A)
(B)
(C)
WALL
STUD
(E)
STEP 2: Once Cleat (E) is anchored to wall, lift Jewelry Mirror (D) to Cleat, fit slot in Mirror over Cleat
then push Mirror LEFT to center and secure.
Push

Customer Service: 800-367-2810
Online: www.ballarddesigns.com Page 4 of 4
Drywall
1/4” Drill Bit
Teeth
Barrel
Create Pilot Hole Tap in Bolt until teeth sink into wall surface.
Turn bolt clockwise until it begins to slip indicating barrel crimp. Remove Bolt. Add Cleat. Replace Bolt.
12
34
INSTALLING EXPANSION BOLTS
WOOD SCREWS
Wood Screws provide optimal support when driven directly
into a Wall Stud. If installation point is over a Wall Stud,
drive Wood Screw directly into Stud.
DO NOT USE WOOD SCREWS IN OPEN DRYWALL.
SCREWS WILL PULL OUT OF WALL.
WALL
STUD
Mark location.Drill small pilot hole with 3/8” bit.
Gently tap Anchor into pilot hole.
Add item/Align holes. Add/tighten screw.
INSTALLING WALL ANCHORS
1
2
3
Cleaning and Care
DO NOT use alcohol based products or spray polishers
as finish damage may result.
Periodically dust with a soft, dry cloth.