Ballard Designs Paulette SK032 User manual

PRODUCT NAME: Paulette Cabinet Base
ITEM NUMBER: SK032
DIMENSIONS OF ITEM ASSEMBLED: 35 3/4”H X 28”W X 18”D
PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 3-3-2020 Page 1 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
MADE IN CHINA

Customer Service: 800-367-2810
Online: www.ballarddesigns.com Page 2 of 4
Hardware Included
Shelf Supports
Ltr.
A
Ltr.
Qty.
8
C 2
D 2
Qty. Components
Shelves (D)
STEP 1:
(D)
(A)
B 4 Wood Plugs
Assemble in location for intended use.
Wall Anchoring
(Anti-tip) Kits
See page 4
REQUIRED TOOLS:
- Phillips Screwdriver
-Two person assembly suggested.
Remove all parts, hardware and
protective packaging from carton
and carefully arrange on a clean,
level, padded surface.
NOTE: To avoid accidentally
discarding small parts or hardware,
retain all carton contents until
assembly and installation are complete.
WARNING
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
ANCHORING HARDWARE INCLUDED
Determine location for each Shelf (D), insert Shelf Supports (A) into pre-drilled holes
then carefully place Shelf upon Supports.

Page 3 of 4
STEP 2: Cabinet is equipped with Rotary Levelers under each corner. If Doors/Drawer are misaligned
or Cabinet is uneven, open doors and insert a Flathead Screwdriver into access hole and
turn Levelers clockwise/counterclockwise to adjust. Cover access holes with Wood Plugs (B).
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
(B)
Assemble in location for intended use.

Installation:
Cleaning & Care:
DO NOT use alcohol based products or spray polisher as
they can damage the finish. Dust with soft cloth.
Ltr.
A2
Small Screw
Retention Belt
Qty. Hardware Included
B2
Large Screw
C4 Bracket
D2
WALL ANCHORING HARDWARE (ANTI-TIP)
1. Place furniture against wall at desired location then locate and mark a Wall Stud behind unit.
2. Corresponding to Stud location, attach one Bracket (C) to back of unit using Small Screw (B).
3. To keep hardware out of view after installation, attach remaining Bracket (C) INTO WALL STUD
with Large Screw (A) 2 inches below Bracket attached to back of unit.
4. Move unit into place, align Brackets then connect both using Retention Belt (D).
5. Confirm Belt is securely laced and locked.
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
W
A
L
L
S
TUD
WALL BRACKET MUST BE ATTACHED TO WALL STUD
(A)
(B)
(C)
(D)
R
e
presen
t
a
tiv
e
Fu
r
nitu
r
e
I
tem
Page 4 of 4