Ballard Designs MT295 User manual

PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 11/11/2019 Page 1 of 3
PRODUCT NAME: Emile Side Table
ITEM NUMBER:MT295
ASSEMBLED DIMENSIONS : 28 1/2”H x 22”W x 15 1/4”D
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
MADE IN ITALY

Customer Service: 800-367-2810
Online: www.ballarddesigns.com Page 2 of 3
Ltr.
A 4
Qty. Components
TOOLS REQUIRED: None
-Two person assembly suggested.
Remove all parts, hardware and
protective packaging from carton
and carefully arrange on a clean,
level, padded surface.
NOTE: To avoid accidentally
discarding small parts or hardware,
retain all carton contents until
assembly and installation are complete.
(A)
INSTRUCTIONS: Gently place Side Table backside down onto a soft, level surface. Insert
threaded stud into T-nut in base of Side Table and turn until firmly tightened.
CAUTION: When returning the table to upright position, DO NOT place side pressure onto
leg(s) as they may break off.
Cleaning & Care:
DO NOT use alcohol based products or spray polisher as
they can damage the finish. Dust with soft cloth.

Page 3 of 3
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Installation:
(B)
(A)
(C)
(C)
(D)
Ltr.
A2 Small Screw
Retention Belt
Qty. Hardware Included
B2 Large Screw
C4 Bracket
D2
ANCHORING HARDWARE (ANTI-TIP)
1. Locate and mark a Wall Stud behind unit at location for installation.
2. Corresponding to Stud location, attach one Bracket (C) to back of unit using Small Screw (B).
3. To keep hardware out of view after installation, attach remaining Bracket (C) INTO WALL STUD
with Large Screw (A) 2 inches below Bracket attached to back of unit.
4. Move unit into place, align Brackets then connect both using Retention Belt (D).
5. Confirm Belt is securely laced and locked.
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
WALL BRACKET MUST BE ATTACHED TO WALL STUD
WALLSTUD
BACK OF FURNITURE ITEM