Ballard Designs Nicola User manual

PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 7-17-2020 Page 1 of 4
PRODUCT NAME: Nicola Sideboard
ITEM NUMBER: SF072
ASSEMBLED DIMENSIONS : 34.5”H x 61.5”W x 18.25”D
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
MADE IN INDONESIA

Customer Service: 800-367-2810
Online: www.ballarddesigns.com Page 2 of 4
Ltr.
A 12
B 2
Qty. Hardware Included
Ltr.
C
D
3
1
Qty. Components
REQUIRED TOOLS:
Phillips Screwdriver
-Two person assembly suggested.
Remove all parts, hardware and
protective packaging from carton
and carefully arrange on a clean,
level, padded surface.
Wall Anchoring
(Anti-tip) Kits
See Page 4
Shelf Supports
Prevent accidentally discarding small
parts or hardware.
Retain all carton contents until
assembly and installation are complete.
Sideboard (D)
Shelves (C) LEFT
RIGHT
CENTER
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
ANCHORING HARDWARE INCLUDED
Assemble in location for intended use.

Page 3 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Assemble in location for intended use.
STEP 1: Determine location for each Shelf (C) and insert Shelf Supports (A) into corresponding
pre-drilled holes. Carefully place each Shelf level upon Supports. NOTE: Left and Right Shelves have
notches in back corners. Center Shelf does not have a notch.
LEVELERS: Sideboard is equipped with Rotary Levelers installed under each leg. Sideboard may be
adjusted by carefully lifting applicable corner and turning Leveler clockwise/counterclockwise. If doors
are misalingned, adjusting Levelers may help with alignment.
Cleaning and Care
Avoid harsh or abrasive chemicals as finish damage may result.
Use coasters, trivets, place mats to protect surfaces. Promply remove spills.
Dust with a soft, dry cloth.

Page 4 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
(B)
(B)
(C)
W
A
LLS
T
U
D
WALL BRACKET MUST BE ATTACHED TO WALL STUD
WALL ANCHORING HARDWARE (ANTI-TIP)
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
R
e
presen
t
a
tiv
e
Fu
r
nitu
r
e
I
tem
Ltr.
A2 Small Screw
Retention Belt
Qty. Hardware Included
B2 Large Screw
C4 Bracket
D2
1. Place furniture against wall at desired location then locate and mark a Wall Stud behind unit.
2. Corresponding to Stud location, attach one Bracket (C) to back of unit using Small Screws (A).
3. To keep hardware out of view after installation, attach remaining Bracket (C) INTO WALL STUD
with Large Screws (B) 2 inches below Bracket attached to back of unit.
4. Move unit into place, align Brackets then connect both using Retention Belt (D).
5. Confirm Belt is securely laced and locked.
(A)