Ballard Designs Sidney TD277 User manual

PRODUCT NAME: Sidney Dining Table
ITEM NUMBER: TD277
ASSEMBLED DIMENSIONS: 30”H x 48” Diameter
PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 7-13-2020 Page 1 of 6
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
MADE IN VIETNAM

Customer Service: 800-367-2810
Online: www.ballarddesigns.com Page 2 of 6
Ltr.
A 8
B
Allen Bolts
Nuts
8
C 1
D
Wrench
Flat Washers
16
E 1
F
Allen Wrench
Lock Washers
16
Qty. Hardware Included
Ltr.
Base (G)
Top Support (I)
Top (K)
Legs (J)
Base Cap (H)
G 1
H 1
I 1
J 4
K 1
Qty. Components
Assemble in location for intended use.
REQUIRED TOOLS:
Wrench (included),
Allen Wrench (included)
-Two person assembly
suggested.
Prevent accidentally discarding small
parts or hardware.
Retain all carton contents until
assembly and installation are complete.

Page 3 of 6
STEP 1: Place Base (G) upright with flat side up then place Top Support (I) on Base. Align holes
with embedded T-nuts in Base.
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Box 1
Box 2
(I)
(G)
CARTON CONTENTS: Box 1 contains Hardware Packet, Top (K), Top Support (I) and Legs (J).
Box 2 contains Base (G) and Base Cap (H).

Page 4 of 6
STEP 2: Secure Top Support (I) to Base (G) using four Allen Bolts (A), four Lock Washers (F) and four
Flat Washers (D). Fully tighten and secure using Allen Wrench (E).
STEP 3: Invert Top (K) onto a level, clean, padded surface. Align holes in Top Support (I) with holes in
Top (K). Secure Top Support (I) to Top (K) using four Allen Bolts (A), four Lock Washers (F)
and four Flat Washers (D).
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
(K)
(I)
(I)
(G)
(F)
(E)
(D)
(A)
(F)
(E)
(D)
(A)

Page 5 of 6
STEP 4: Orient and insert Legs (J) into Base (G) as illustrated.
STEP 5: Secure Legs (J) to Base (G) using eight Nuts (B), eight Washers (D) and eight Lock Washers (F)
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
(G)
(J)
(G)
(J)
(F)
(D)
(B) (C)

Page 6 of 6
STEP 6: Attach Base Cap (H) to Base (G) by inserting and turning clockwise. Do not over tighten.
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Cleaning and Care
Avoid harsh or abrasive chemicals as finish damage may result.
Use coasters, trivets, place mats to protect surfaces. Promply remove spills.
Dust with a soft, dry cloth.
(H)
(G)
(J)
STEP 7:Table is equipped with Rotary Levelers installed under each Leg (J). If necessary, Table may
be adjusted by carefully lifting applicable Leg and turning Leveler clockwise/counterclockwise.