Body Craft F412 Installation guide

PARTS CHART
0
(inch) 1" 2" 3"1/21/4 3/4 1/2 1/2 4" 5" 6"1/2 1/2 1/2
NO. DESCRIPTION QTY.
NO. DESCRIPTION QTY.
NO. DESCRIPTION QTY.
201
202
203
204
205
1
1
1
1
1
PEC DEC SUPPORT
PEC DEC PULLEY FRAME
LEFT PEC DEC ARM
RIGHT PEC DEC ARM
SINGLE PULLEY BRACKET
8
2
4
3
2
1
1
50 SQ. END PLUG
3/8" BUSHING
3/4" METAL BUSHING
PULLEY
FOAM PAD
BACK PAD
PEC DEC CABLE
2
1
2
3
2
4
4
4
4
1/2" X 3-1/8" HEX HEAD BOLT
3/8" X 2-3/4" HEX HEAD BOLT
3/8" X 2-3/4" HEX HEAD BOLT
3/8" X 1-3/4" HEX HEAD BOLT
1/2" WASHER
1/2" WASHER
3/8" WASHER
1/2" NYLON NUT
3/8" NYLON NUT
211
212
213
214
215
216
217
221
222
223
224
225
226
227
228
229
221 222 223 224
225 226 227
228 229
217 (2380mm)
216
215
214213212211
201 205 202
203 204
ASSEMBLY INSTRUCTION MANUAL
MODEL: F412 PEC DEC ATTACHMENT

B: CABLE ASSEMBLY OF PEC DEC ATTACHMENT
A: ASSEMBLY INSTRUCTION OF PEC DEC ATTACHMENT
Thank you for purchasing the Bodycraft Smith Attachment
Strength Training System. If You have any questions,
please call your local BodyCraft dealer or call our
customer service department at 800-990-5556.
1. Attach Pec Dec Support(201) and Pec Dec Pulley Frame(202) to Front Upright(101) using two Bolts(221) ,
four Washers(226) and two Nuts(228).
2. Insert four 3/4" Metal Bushing(213) into Pec Dec Support(201). Insert Right Pec Dec Arm(204) through the
hole on Pec Dec Support(201) , tighten Bolt(228) and Washer(225) and back off approximately 1/2 turn so
that arm moves freely. Repeat the same process to Left Pec Dec Arm(203).
3. Attach End Cap(211) onto the Pec Dec Support(201) and both Pec Dec Arm(204).
4. Wet the Foam Pad(215) and slide onto both Pec Dec Arm(203 , 204).
5. Attach Back Pad(216) on Front Upright(102), using two Bolts(221) and Washers(226).
Assemble cables and pulleys simultaneously.
1. Unhook the terminal end of Low Cable(137) and hook on the single Pulley Bracket(205). As shown Fig C.
2. Insert the Pec Dec Cable(217) through the Single Pulley Bracket(205) , over the pulley on Pec Dec Pulley
Fra me(202) and attach steel ball end on cam of both Pec Dec Arm. As shown Fig B.
D
229
227
227
212
212
222
214
C
224
214
229
205
B
203 or 204
B
C
D
A
A
A
214
215
215
211
211
211
211
211
221
221
216
102
211
211
204
203
221
226
202
201 224
224
228
228 226
229
213
213
213
225 228
213
225