BROSA Alpha Table Lamp User manual

ASSEMBLY GUIDE
Alpha Table Lamp
v1.0

Components
Before you get started, check you have all of the pieces below. If anything’s
missing, please visit www.brosa.com.au/pages/product-return-and-parts-request
and we’ll sort it out right away.
Pole x 2 Base x 1
Shade x 1
Hardware
What you need
A x 2 B x 1
12
3
4

Safety
1. For indoor use only
2. Follow instructions carefully. Any deviations may be hazardous, or void
your warranty.
3. Damaged power cords must be replaced by a professional.
4. Never use a bulb of a greater wattage than recommended.
5. To replace the bulb, unplug the lamp from its power source and allow it to
6. Periodically check and re-tighten all screws and fasteners.
8. Firmly secure all pieces. Small parts may present a choking hazard.
9. Bulb is not included.
MAX 25W E14
220-240v ~ 50Hz

Step 1 Step 1.1 Align the top pole (1) with the bottom pole
(2) and rmly screw them together.
Step 1.2 Attach this to the base (3) and secure the
joint using a bolt (A) and Allen key (B).
Step 1.3 Adjust the bulb socket so that it faces
straight forward (as pictured).
Step 1.4 Gently screw the correct bulb (not included)
into the bulb socket.
Step 1
A x 1
B x 1
Step 1.1
Step 1.2
Step 1.4
Step 1.3
1
2
3
A
B

Step 2 Position the shade (4) over the bulb. Make
sure the bracket inside the shade overlaps with the
hole on the top of the stand. Fix the shade into place
using a bolt (A) and Allen key (B).
A x 1
B x 1
4
A
B

Step 3 Adjust the bulb holder ensuring it is level. Check all
other parts are secure.
Enjoy! We hope your new lamp lights up your life.