BROSA Kraesten Armchair User manual

ASSEMBLY GUIDE
Kraesten Armchair
v1.0

Components
Upon unpacking your chair from it’s delivery box, you should have one single
component (the body of the chair). Additional components are packed inside
the body, you will learn how to access and utilise these components in the
next steps.
Turn the chair body so that the underside is facing you. Remove the material
from the underside of the chair body to reveal the other counterparts of the
chair. Take out all of these parts and do not replace the material, you will
need access to the screw holes to attach the legs. But hold onto the material
as you will reattach it later.
Chair body x 1
Unpacking
A x 4 (Leg)
B x 8 (Bolt)
C x 8 (Washer)
E x 1 (Allen Key)
D x 8 (Spacers)

Align a leg (A) so that the screw slots are overlapping.
Fit a spacer (D) followed by a washer (C) to a bolt (B)
and t it into one of the screw holes. Repeat for the
second screw to t the leg onto the body of the chair.
Turn the bolt with the allen key (E) until it is secure
but do not tighten yet.
Repeat for all four legs.
Step 1
D x 8
C x 8
B x 8
A x 4
E x 1
Step 2 Lift the chair o the ground and turn it right side up
while being careful not to put any pressure on the
legs while you turn the chair.
A
B
D
CE

E x 1
Step 3 Place the chair on a at surface, then sit on the chair
and shift your weight around until the legs are level
and the chair does not rock. en use the allen key
(E) to tighten all the bolts.
Turn the chair upside down one last time and pull
the material cover to conceal the underside of the
chair and secure it back into its original place.
Lift the chair and place it on its legs and now enjoy
your new armchair!
Step 4