BROSA Ethan User manual

ASSEMBLY GUIDE
Ethan Dressing Table

Components
Upon unpacking your dressing table from it’s delivery box, you should have the pieces
shown below. Follow the steps on the next pages to assemble your new table.
15MIN
x 1
Drawer Box Unit
2
1
Hex head bolt
M8 x 12 x 30mm
Allen key
M4 x 30 x 107mm
Mounting Plate
Nylon Strap
Flat head screw
4 x 17mm
x 12
x 1
x 2
x 1
x 2

Step 1
A x 12
1.1 Lay drawer box unit (2) on at surface. Position both leg
frames (1) onto pre-drilled holes on drawer box unit (2) as
shown. Ensure the pre-drilled holes on leg frames (1) are
aligned correctly with the pre-drilled holes on drawer box unit
(2) before attaching.
1.2 Secure leg frames (1) to box unit (2) using hex bolts (A) as
shown. Use allen key (B) to turn bolts (A) clockwise to tighten.
B x 1
Assembly is complete.

Tip Kit Instructions
Notice: To prevent injury and property damage from unexpected tipping of furniture, we
highly recommend installation of the anti-tip kit included with this project.
Attaching furniture to wall with anti-tip kits.
1.
2.
3.
4.
5.
Determing where the piece is to be placed and mark location on the wall for the
mounting bracket screw holes. ey should be place approximately 1” below the
bottom of the back of the piece of furniture.
Drill the hole and use the appropriate wall plug that is suitable for your walls
composition. Warning: before drilling check wall for hidden pipes and cables.
Attach the mounting bracket vertically to the wall using appropriate fastener,
through the holes in the bracket and 2 wall plugs that are suitable to your wall and
then tighten securely.
Next using the short screws attach the 2nd bracket to the back of the piece of
furniture’s top.
Lace the nylon strap through the brackets. Slide the thin end of the strap through the
receiving end of the nylon strap. Pull to tighten the piece of furniture snug against
wall.
Wood Brick or Masonry Cavity Wall
If fixing to
wood make
sure that is
isn’t
chipboard as
screws can
easily pull
away from
the core
structure.
Use an
appropriate
wall plug
provided
when you are
sure your
wall is sound.
Special
toggle wall
plugs are
needed.
Seek expert
advice.