BROSA William Armchair User manual

ASSEMBLY GUIDE
William Armchair
v1.0

Components
Upon unpacking your armchair from its delivery box, you should have one
single component (the body of the chair). Additional components are packed
inside the body, you will learn how to access and utilise these components in
the next steps.
Chair body x 1
Turn the chair body so that the underside is facing you. Remove the cover
from the base of the chair to reveal a hidden compartment where you’ll nd
the rest of the parts of the chair. Take these out and leave the cover o as you
need access to the underside of the chair to t the legs.
Unpacking
A x 4 (Leg)
B x 8 (Bolt)
C x 8 (Spring Washer)
D x 8 (Flat Washer)
E x 1 (Allen Key)

Step 1 Insert a leg (A) into the corresponding slot. Fit a spring
washer (C) to a bolt (B) followed by a at washer (D)
and screw it into one of the holes. Repeat for the
second bolt (B) to t the leg into the frame of the chair.
Turn the bolt (B) with the allen key (E) until it is secure
but do not tighten yet. Repeat for all remaining legs.
A
A A
A
D B EC
Step 2 Lift the chair o the ground and turn it right side up
while being careful not to put any pressure on the
legs while you turn the chair.
A x 4
B x 8
D x 8
C x 8
E x 1

Step 3 Place the chair on a at surface, then sit on the chair
and shift your weight around until the legs are level
and the chair does not rock. en use the allen key
(E) to tighten all the bolts and replace the cover on
the underside of the chair body to conceal the
hidden compartment. Enjoy your new armchair!
E x 1