BROSA Parc Extendable Dining Table User manual

ASSEMBLY GUIDE
Parc Extendable Dining Table
v2.0

Components
Upon unpacking your extendable dining table from it’s delivery box, you
should have the separate pieces shown below. Follow the steps on the next
pages to assemble your new extendable dining table.
Hardware
A x 6
Spec: 5/16 x 30
B x 6
Spec: Ø8 x Ø14
D x 4 F x 1
Spec: Ø10 x 40
E x 4
Spec: M8
G x 1
Spec: 10g
H x 1
Spec: 5#
I x 2
Spec: 14#
C x 2
Spec: M8 x 95
Table top x 1
Leg x 2
1
2
2
What you need

Step 1
Step 1.1
D x 4
E x 4
C x 2
1.1 Place a small amount of glue (G) onto the dowel
(F) on one half and insert it into the middle hole of a
leg (2) as shown in the diagram. Insert the threaded
rods (C) into each of the outer holes and apply some
more glue (G) on the other half of the dowel (F). Align
the two legs (2) to each other and rmly press
together. Fit a half-lunar washer (D) to one end of the
threaded rod followed by a nut (E). Repeat for the
other end of the rod (C).
1.2 Tighten the nuts on both sides at the same time
using the spanners (I).
Repeat the whole process for the other rod.
C
ED
F
G
2
2
F x 1
I x 2
G x 1
Step 1.2
I
I

Step 2 Align the leg structure formed in Step 1 to the under-
side of the table top (1) so that all of the screw holes
overlap. Fit a washer (B) to a bolt (A) and screw into
each hole and use the Allen key (G) to tighten all in
place.
B x 6
H x 1
A x 6
1
A
B
H

Step 3 Gently lift the table and place upright on a level
surface. Under the table unlock the slides on both
sides by lifting the latch and release both of the locks
by lifting the latch and unhooking the loop.
Warning: before moving the table (anytime), ensure
that all of the locks and slides are locked.
Step 4 Pull the two halves of the table apart until they are
fully extended. Flip and unfold the leaf to be level
with the top surface of the table.
1
2
x 2
x 2

Step 5 Push either side of the two halves and rmly press
the two halves and the leaf together. Under the table
lock the slides on both sides by pressing down the
latch and relock all of the locks by hooking the loop
and pulling down the latch.
Step 6 e extendable dining table is 120cm long without
extension and 160cm long when fully extended. It is
120cm wide and 76cm high and can take up to 60kg
maximum weight on top. Enjoy your new table!
2
1
x 2
x 2
60.0cm 40.0cm 60.0cm
76.0cm
120.0cm
60KG
MAX