BROSA Mistral Dining Table User manual

ASSEMBLY GUIDE
Mistral Dining Table
v1.0

Components
Before you get started, check you have all of the pieces below. If anything’s
missing, please visit
www.brosa.com.au/pages/product-return-and-parts-request and we’ll sort it
out right away.
Table Top x 1 Base x 1 Leg x 4
Hardware
What you need
A x 4 B x 8 C x 14 D x 8 E x 6 F x 6
G x 1 H x 1
1
2
3

Step 1 Step 1.1 Insert a cross dowel (A) into the hole at the
top of the leg (3), making sure that the threaded
sockets in the dowel are aligned with the holes on
the inner face of the leg. Repeat this for the remain-
ing legs.
Step 1.2 Insert a threaded rod (B) into the hole on
the inner face of the leg (3). Screw it tightly in place.
Repeat this for another hole and then repeat the
process for the remaining legs.
A x 4
B x 8
Step 1.1 Step 1.2
A
B
3

Step 2 Align a leg with the base (2), making sure the thread-
ed rods protruding from the leg t into the holes in
the base. Fit a at washer (C) to the rod followed by
a hex nut (D). Use the spanner (G) to tighten the nut
in place. Repeat this for the other rod and then
repeat the process for the remaining legs.
C x 8
D x 8
G x 1
C
D
G
2

Step 3 Align the formed structure with the table top (1). Fit
a spring washer (E) to a bolt (F) followed by a at
washer (C). Fit the bolt into a hole on the base and
x it with the Allen key (H). Repeat this for the
remaining bolts.
C x 6
E x 6
F x 6
H x 1
C
E
F
H
1

Step 4 Gently lift the table and place it upright on a level
surface. Enjoy your new dining table!