BROSA Field Wide Sideboard User manual

ASSEMBLY GUIDE
Field Wide Sideboard
v1.0

Components
A x 12
(Bolt)
B x 1
(Allen key)
Hardware
What you need
Left Leg x 1
Right Leg x 1
Body x 1
Shelf x 2
aa x 2
(Mounting Plate)
bb x 1
(Nylon Strap)
cc x 2
(Screw)
Before you get started, check you have all of the pieces below. If anything’s
missing, please visit www.brosa.com.au/pages/product-return-and-parts-request
and we’ll sort it out right away.
3
2
1
4
C x 8
(Shelf Support)

Step 1 Align the legs (2, 3) to the underside of the body (1)
so that the holes are overlaping. Secure them with
bolts (A) using an allen key (B). With a help of the
partner lift the storage and place on it’s legs on a
level surface.
A x 10
B x 1
B
3
2
A
1

Step 2
C x 8
Step 2.1
Step 2.2
Step 2.2
Step 2.3
1.1 Insert a pair of shelf supports (C) into the side
holes in the compartment and another pair in facing
holes on the same level.
1.2 Tilt the shelf (4) so it ts into the opening. Insert
the shelf .
1.3 Lower the shelf until it rests securely on all four
supports.
1
4
4
С
С

Step 3 hinges if needed.

Step 4 Turn the twist inside of the drawer to adjust it’s ver-
tical position, so that there are exqual gaps above
and below the front wall.
+2.5
-2.5

UNLOCK
Step 5 To take the drawer out, open it, pull out the Lock
button inside of the drawer. Gently lift the front part
of of the drawer.

Step 6 To put the drawer back in, attach the connector in
the back of the drawer. Gently put down the front
part of of the drawer so that the front connectors
attach. Push back the Lock button inside of the
drawer.
LOCK

Step 7 Fix a mounting plate (aa) to the back of the storage
using at head screws (cc).
By using appropriate fastener based upon wall com-
position, x another mounting plate (aa) to the wall.
Connect two plates with the nylon srap (bb).
Tighten the strap so that the table is xed in the
place.
aa x 2
cc x 2
bb x 1
cc
cc
aa
WALL
aa bb
aa

Step 8 Enjoy your new storage!